User manual AEG-ELECTROLUX KF1022AROMA

[. . . ] In this case, the use of carbon filters is absolutely necessary . Carbon filters are available separately and can be purchased as optional accessories (see OPTIONAL ACCESSORIES). BEFORE MOUNTING Before mounting you should: Check that the minimum distances between the lower part of the cooker hood and the upper part of the cooker as given in FIGURES M 1. We advice a distance between 700 and 800 mm. [. . . ] Fixed installation; installation by means of plug on a socket. Check that the electrical data indicated are in conformity with the main voltage and frequency values of the building where the hood is to be installed; Check that the building is fitted with electric safety systems to protect against short circuits and electric shock systems, according to the laws in force; Install an electric socket (or connection point) with a bipolar switch, which has contacts with an opening of at least 3 mms; If it is intended to install the hood with a plug, it is necessary that you have access to the plug. Always turn off the main voltage supply by means of the bipolar switch before connecting and switch on again only when connections have been completed, tested and are safe. I When the hood is in stand by the intensity of the light is reduced. PRECAUTIONS TO BE TAKEN IF REPAIRS ARE TO BE CARRIED OUT Repairs must be carried out only by our SERVICE CENTERS. It is necessary to use only original spare parts. Any repairs carried out by others could prove to be dangerous and could be a fire risk. 35 INSTRUCTIONS FOR USE and PRECAUTIONS The hood must be mounted and connected in a proper way. Everything that is necessary to do that you find in the instruction manual. The hood is not proper for the use of people (children included) with reduced mental, physical and sensorial capacities or for people that have no experience or knowledge to use it, unless they have been trained on purpose by the person responsible for their security or they acquire experience or knowledge from the instruction booklet. Do not to cook "flambé" dishes, avoid flames directly underneath the hood; Avoid free flames underneath the hood; Avoid any strong flames being issued from under saucepans at the sides; when frying, do not allow oil to splash or overheat in the pan, as this is a fire risk; before any cleaning or maintenance operation, disconnect the hood from the main supply, by means of the main switch or the bipolar switch or by removing the plug; A contemporary use without danger of appliances connected to pipes (like fireplaces or gas equipment) with the hood is allowed only if the room or flat have a proper opening for 2 air arriving from the outside of circa 500/600 cm and if with the hood working a depression is avoided. Keep pressing at the same time the push and one of the speeds // button at which you wish to set the interval function. That is Press Press Press and and and for the first speeed for the second speeed for the third speeed Press within 5 seconds the push button to confirm the speed for the motor you wish for the interval function. Setting of the interval function by the remote control: , , . Press the push button : the light indicator will show first speed, press again the push button the light indicator will show the following for the speeds of the motor 23123 . ; Press within 5 seconds the the interval function. Push button to confirm the speed for the motor you wish for By pressing any push button, light excluded, the interval function is excluded. the remote control has a battery (type 23 A). When the battery is exhausted you need to: loosen the 2 screws on the rear part and remove the cover; take the battery out and replace it with one with the same characteristics. Close the cover again and tighten the screws. Follow National norms for waste disposal of exhausted batteries. SATURATION INDICATORS OF GREASE FILTERS AND CARBON FILTERS The hood is delivered standard in suction use: if you wish to use the hood in filtering version it is necessary to set this function. [. . . ] We recommend washing grease filters after 50-100 hours of use of the hob. If grease filters are dirty, motor can take in just a small quantity of air and performance is reduced. The grease which accumulates on dirty filters is easily inflammable and can cause fires, if not eliminated by periodic washes. The manufacturer declines any responsibility for fires caused by poor maintenance of the grease filters. [. . . ]