User manual AEG-ELECTROLUX KF5110

[. . . ] Onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Clean and/or replace the Filters after the specified time period (Fire hazard). Clean the hood using a damp cloth and a neutral liquid detergent. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Ty Product Components 1 Hood Body, complete with: ConEN 1 trols, Light, Blower, Filters 8 1 Directional Air Outlet grille 9 1 Flange ø 150 mm 10 1 Flange with Valve ø 150 Ref. This operation must be carry on by the service agent or similarly qualified persons in order to avoid a hazard. Remove the profile after unfastening the 4 screws that fix it to the Hood (fig. By removing the 6 upper screws, the 6 rear screws and the 2 screws on the inside of the Hood, it is possible to turn the Motor Unit with the bracket attached so that the air outlet points to the side (fig. 4) unfasten from the inside the screws that fix the upper part containing the motor to the rest of the Hood. The alarm is triggered after 100 working hours. (Reset; check the Maintenance-paragraph) indicates that the activated charcoal odour filter satura-tion alarm has been triggered , and the filter has to be re-placed; the metal grease filters must also be washed. The activated charcoal odour filter is triggered after 200 working hours. The appliance can be controlled using a remote control powered by a 1. Do not place the remote control near to heat sources. Used batteries must be disposed of in the proper manner. Clean the outside by using a damp cloth and neutral liquid de-tergent. Clean the inside as well by using a damp cloth and neutral de-tergent; do not use wet cloths or sponges, or jets of water; do not use abrasive substances. When the above operation has been completed, hook the panel back to the hood canopy and close it by turning the knob in the opposite direction. Switch off the lights and extractor motor. Press button T3 for at least 3 seconds, until the leds start to flash. [. . . ] Press button T3 for at least 3 seconds, until the leds start to flash. The filters are washable and must be cleaned at least every 2 months of operation, or more frequently for particularly heavy usage. Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. Wash the filters, taking care not to bend them. [. . . ]