User manual AEG-ELECTROLUX KF810

[. . . ] Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility orcontact your municipal office. CustoMEr CArE AnD sErviCE We recommend the use of original spare parts. When contacting Service, ensure that you have the following data available The information can be found on the rating plate. [. . . ] Model ___________________________ PnC ____________________________ serial number ____________________ 4 rECoMMEnDAtions AnD suGGEstions · The instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. The manufacturer will not be held liable for any damages resulting from incorrect or improper installation. The minimum safety distance between the cooker top and the extractor hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation). Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. For class i appliances, check that the domestic power supply guarantees adequate earthing. Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible. Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc. Clean the hood using a damp cloth and a neutral liquid detergent. English 5 ControLs Button Function Display a Decreases the working speed or exits timed intensive speed. At the end of the 10 minutes intensive speed will automatically drop to the level below and the last LED will go out. Flash from button C indicates that the activated charcoal Touch and hold for 5 seconds to enable/disable the Filters alarm is activated activated charcoal Filters alarm. Flash from button a indicates that the activated charcoal Filters alarm is deactivated increases the lighting intensity With the filter alarm active, press the button to Reset the When the procedure terminates, the indication shown previously turns off: Button lit indicates the need to wash the metal grease filters. These indications are only visible when the alarm is triggered after the Hood has been in operation for 100 working motor is turned off. Button Flashing indicates the need to change the activated charcoal filters, and also to wash the metal grease filters. The alarm is triggered after the Hood has been in operation for 200 working hours. When it is activated, the luminosity of the button changes from 50% to 100% intensity. [. . . ] The alarm is triggered after the Hood has been in operation for 200 working hours. When it is activated, the luminosity of the button changes from 50% to 100% intensity. When it is deactivated, the luminosity of the button changes from 100% to 50% intensity. When the Hood is switched off, none of the functions is displayed, and only the normal lettering on the control panel is visible. [. . . ]