User manual AEG-ELECTROLUX KM450

[. . . ] · In order to avoid danger, if the connection lead of this appliance is damaged, it must be replaced by the manufacturer, its customer service department or a similarly qualified person. 9 g · Repairs to the appliance may only be carried out by trained personnel. As a result of incorrect repairs considerable dangers for the user may result. Please contact the AEG customer service department or your dealer in the event of repairs being necessary. · Never switch on the appliance until the working attachments are in the mixing bowl with the ingredients to be processed. [. . . ] The mixer and mixing bowl are each driven separately by their own motors, and the speeds of the mixer and mixing bowl can be individually adjusted. However the mixer/processor has a single ON/OFF switch. The mixer can be easily removed from the processor stand in a moment and used as a standard hand mixer. When used in this way, move the hand mixer in a smooth circular motion around the inside of the bowl containing the ingredients. Inserting/removing accessories (Figure 3) Before releasing the accessories, switch off the mixer and remove the plug from the mains socket!0 Push the whisks or dough hooks into the accessory slots on the underside of the mixers, until they click into place. 1 The two dough hooks have different plug shapes and must be pushed into the correct slots. Insertion the wrong way round would lead to the dough being transported upwards!0 One of the dough hooks has an additional small ring near the collar on the shaft. This dough hook will only fit in the slot for which it is intended. This is identified by a symbol. 1 3 The dough hooks (Figure 1/M) are used for heavy doughs, such as yeast dough, short crust pastry, potato batters and cake mixes. The whisk (Figure 1/L) is suitable for light cake mixes, egg white, cream, mayonnaise, purées and for stirring sauces and dessert powders. · KM 400 models are supplied with a plastic mixing bowl. · KM 450 models are supplied with a stainless steel mixing bowl with lid. 0 To remove the accessories, hold firmly with one hand, while pressing the accessory release button (Figure 1/A). Raising/lowering the mixer (Figure 4) 1 Preparing for use Fitting the mixer to/removing from the processor stand (Figure 2) Ensure that the mixer is switched off before raising/lowering!0 Press the raise/lower button (Figure 1/F) and swing the mixer up or down, until it clicks in place. 3 With the mixer raised, the accessories can be easily changed and the mixing bowl located on the processor stand or removed. 1 Before fitting or removing the mixer, switch off the processor/mixer and remove the plug from the mains socket!0 To fit, push the mixer on to the processor stand (the two latches on the processor stand engage in the mixer) and press down to lock. 0 To remove, press the lock release (Figure 1/G) and pull the mixer upwards. Locating/removing the mixing bowl (Figure 5) 0 Locate the mixing bowl on the guide on the base and latch in place by gently turning clockwise. 0 To remove the mixing bowl, turn anticlockwise to unlatch. 3 It may be necessary to hold the base to prevent it rotating. The off-centre position of the mixer makes it easy to add ingredients while the processor is in operation. 11 g Working with the mixer/ processor 1 When the mixer is attached to the processor stand, the mixing bowl is automatically switched on when the mixer is switched on. The mixer must not be run continuously for more than 10 minutes at a time. After this time, allow to cool for at least 20 minutes before re-using. Maximum processing quantities: Processing in the mixing bowl must not exceed 1. 5 kg solid or 1. 75 l liquid foodstuffs. 0 The ON/OFF switch (Figure 1+6/B) is used to: ­ switch the mixer ON and OFF, ­ control the mixer speed (5 speed settings) in the pre-selected speed range. [. . . ] Diese Garantie räumt dem Verbraucher also zusätzliche Rechte ein. Dies vorausgeschickt, leisten wir, AEG Hausgeräte GmbH, gegenüber dem Verbraucher Garantie für dieses Gerät für den Zeitraum von 24 Monaten ab Übergabe zu den folgenden Bedingungen: 1. Mit dieser Garantie haften wir dafür, dass dieses neu hergestellte Gerät im Zeitpunkt der Übergabe vom Händler an den Verbraucher die in unserer Produktbeschreibung für dieses Gerät aufgeführten Eigenschaften aufweist. Ein Mangel liegt nur dann vor, wenn der Wert oder die Gebrauchstauglichkeit dieses Geräts erheblich gemindert ist. [. . . ]