User manual AEG-ELECTROLUX KWA9

[. . . ] such damage is not covered by the warranty. Never use the vacuum cleaner without its filters. Disconnect the plug from the mains before cleaning or maintenance of the vacuum cleaner. All servicing and repairs must be carried out by an authorised Electrolux service centre. [. . . ] Open the front cover on the machine and check that the dust bag, s-bag® and the motorfilter are in place. (See also Replacement of filter(s)) 10 Open the back lid on the machine and check that the exhaust filter is in place. 11 Insert the hose until the catches click to engage (press the catches to release the hose). Insert the hose into the hose handle until the catches click to engage (press the catches to release the hose). Push same button once more to turn it off. Power Regulation: Twist the power control towards , , max" to increase the suction power. Twist the power control towards , , min" to decrease suction power. additional suction power control: Use the suction control on the hose handle. Practical parking positions (and at the same time a backsaving feature) when you pause during cleaning or when you carry and store the vacuum cleaner. You can also carry the vacuum cleaner using the handle on top or on the lower front edge of the machine. Keep the hose in place while storing the vacuum cleaner by extending the elastic bumper cord and placing it across the hose. Carefully pull the old, dirty filter(s) out of the filter holder and replace with a new filter(s). 31 Reattach the filter holder containing the new filter(s). Put the insert holding of s-bag® back in the cleaner and then close the cover. The filters must always be replaced with new ones and cannot be washed (if not mentioned). 32 Place your thumbs on the back edge of the lid and then open the lid by pulling the handle backwards and upwards with your index/middle finger. Rinse the inside (dirty side) of the filter unit under warm tap water only. Repeat cleaning procedure four times and allow the filter to air dry. the original filtering performance is now restored. Replace the unit back into the cleaner and close cover ensuring it is properly fastened. In such cases, disconnect from mains and allow to cool for 20-30 minutes. Use a cleaning strip or similar to clear the tubes and hose. [. . . ] 36 It may also be possible to remove the obstruction in the hose by squeezing it. However, be careful in case the obstruction is caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to the hose caused by cleaning it. To avoid deterioration of suction power, frequently clean the carpet/ hard floor nozzle. [. . . ]