User manual AEG-ELECTROLUX L105

[. . . ] The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. Tips and information about economical and ecological use of the machine are marked with the clover symbol. If you require assistance or advice on your appliance, please contact our customer care department by letter or telephone: Customer Care Department AEG Domestic Appliances 55-77 High Street Slough Berkshire SL1 1DZ Tel: 08705 350350* * calls to this number may be recorded for training purposes. Important Your machine is fitted with a balance control device, which ensures the machine is stable during the spin. If the wash load appears not to have been spun sufficiently at the end of the wash cycle, because it is not evenly distributed in the drum, the balance control device may have operated. [. . . ] If the programme selector dial is positioned on a wash programme, the duration of that programme will be displayed. ON / OFF 23 132996260. qxd 7/24/01 9:12 PM Pagina 24 (Nero/Process Black pellicola) How to wash Selection of the desired wash programme Turn the programme selector dial to the desired position: the lights corresponding to the different phases making up the selected programme light up. The display shows the duration of the programme. PREWASH WASH RINSES EXTRA RINSE SPIN DRYING END OVERDOSAGE SHORT SPIN LONG SPIN DRAIN SOFTENERS RINSES COLD 95 COTTONS LINENS ECONOMY 60 50 40 30 DRYING WOOL 30 40 COLD 30 40 40 40 60 50 SYNTHETICS EASY TO IRON DELICATES DRYING 1000 Selection of the SPIN SPEED or NO SPIN option To select the desired spin speed, press the SPIN SPEED button: the corresponding light comes on. When selecting the NO SPIN option all the spinning phases are suppressed. SPIN SPEED 900 700 500 NO SPIN Selection of the STAIN, PREWASH or QUICK WASH option, depending on the degree of soil of the laundry and on the type of fabric. The corresponding light comes on. PREWASH STAIN QUICK Selection of the RINSE HOLD and/or EXTRA RINSE option The corresponding light(s) come(s) on. RINSE HOLD EXTRA RINSE Selection of the DELAY START option To delay starting of a programme, press the DELAY START button before starting the machine. The figures corresponding to the selected delay will be displayed for about 3 seconds, after which the duration of the selected programme will appear on the display. When the START/PAUSE button is pressed, the selected delay will again appear on the display and the machine starts its countdown. DELAY START 24 132996260. qxd 7/24/01 9:12 PM Pagina 25 (Nero/Process Black pellicola) How to wash Starting the programme To start the selected programme, press the START/PAUSE START button; the corresponding light stops flashing. PAUSE The pilot light corresponding to the wash phase which is running is illuminated. If the delay start option has been selected, the machine starts its countdown, in hours, which will appear on the display. During this period it is possible to load other laundry: press the START/ PAUSE button. Close the door and press the START/ PAUSE button again. At the end of the programme The machine stops automatically and a flashing zero is displayed. If the RINSE HOLD option has been selected, the corresponding pilot light on the programme progress display remains lit to indicate that the water must be emptied out before opening the door. Select the hottest cotton wash programme. Use a normal measure of detergent, must be a powder (such as Ariel Futur). Periodical cleaning Exterior Clean the outside of the cabinet with soap and water only. Important: do not use methylated spirits, solvents or similar products to clean the cabinet. Detergent dispenser drawer After a while, detergents and fabric softeners leave deposits in the drawer. Clean the drawer, from time to time, by rinsing it under a running tap. To remove the drawer from the machine, press the button in the rear left-hand corner. 28 132996260. qxd 7/24/01 9:12 PM Pagina 29 (Nero/Process Black pellicola) Cleaning and maintenance To facilitate cleaning, the top part of the additive compartment can be removed. Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Refit the drawer after cleaning. Door seal Regularly check to see, if there are deposits or foreign objects in the rubber seal behind the door and remove them. Drain filter The drain filter collects threads and small objects inadvertently left in the laundry. Check regularly that the filter is clean. Place a container under the filter and unscrew it; some water will come out of the filter. Clean the filter under a running tap, then refit it, screwing it fully in. Water inlet filter If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked. [. . . ] 570 m 820 min 195 8 Preparation and assembly of the door The machine is originally prearranged for the assembly of a door opening from right to left. In this case it is sufficient to screw in the hinges (1) and the countermagnet (6) provided with the appliance, at the right level (Fig. B). 6 4 1 1 165 A 2 7 3 160 90 0 49 120 541 5 a) Door 23 8 The dimensions of the door should B be: - width 595-598 mm - thickness 16-22 mm The height (C-Fig. C) depends on the height of the adjacent furniture's base. 35 Ø 12. 5-14 depth b) Hinges 16 -22 To mount the hinges it is necessary to drill two holes (dia. [. . . ]