User manual AEG-ELECTROLUX L1245EL

[. . . ] LAVAMAT L 1045 EL LAVAMAT L 1245 EL The environmentally friendly washing machine Instruction booklet LAVAMAT 1000 900 700 400 F D C B A 30 40 95 E 60 50 40 30 L 1045 EL UPDATE 30 40 40 40 60 50 AUS ERFAHRUNG GUT Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. This symbol guides you, step by step, in the operation of the appliance. [. . . ] To remove it press buttons and again until the light comes off. Selection of the DELAY START option To delay starting of a programme, press the DELAY START button before starting the machine. The figures corresponding to the selected delay will be displayed for about 3 seconds, after which the duration of the selected programme will appear on the display. If button (SOAK) has been pressed the selected delay will correspond to the soak time. If no delay time is selected the soak programme will last about 30 minutes. When the START/PAUSE button is pressed, the selected delay will appear again on the display and the machine starts its countdown. 23 How to wash Starting the programme 1. Press START/PAUSE to start the programme. If the Delay Start option has been selected the programme will start at the end of the countdown. If the door light is red and flashing at the start of the programme it indicates that the door is open. Close the door and press the START/PAUSE button again. If the delay start option has been selected, the machine starts its countdown, in hours, which will appear on the display. During this period it is possible to load other laundry, to modify or cancel the delay time. · Load other laundry: press the START/PAUSE button. Close the door and press the START/PAUSE button again. · Modify or cancel the delay time: press the START/PAUSE button. Press the DELAY START button until the time required appears on the display, or 0h, if you wish to cancel it. Press the START/ PAUSE button again. Programme progress display By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on. After the machine has started, only the running phase pilot light stays on. PREWASH WASH RINSES EXTRA RINSE SPIN END OVERDOSAGE Display The time to the end of the programme decreases minute by minute and appears on the display. 24 How to wash At the end of the programme The machine stops automatically. The END light comes on in the programme progress display. If the light (OVERDOSAGE) comes on it indicates that too much detergent has been used. At the next wash carefully follow the detergent manufacturer's instructions. Measure out detergent according to amount, type, degree of soil of fabrics and water hardness. This light could come on also when the drain filter is blocked. [. . . ] 39 Installation Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. · Before placing it on small tiles, apply a rubber coating. · Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine. [. . . ]