User manual AEG-ELECTROLUX L1246EL

[. . . ] LAVAMAT 1046 EL LAVAMAT 1246 EL Washing Machine Instruction Booklet 1046EL 1200 900 700 500 95 95E 60 40 - 60 MIX 40 30 30 40 30 40 40 40 60 50 PERFEKT IN FORM UND FUNKTION Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. This symbol guides you, step by step, in the operation of the appliance. [. . . ] However, for people with a very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water (extra rinse). The extra rinse is available only with the cotton, synthetics or delicate programme. Selection of the EXTRA RINSE option Press simultaneously buttons SPIN SPEED and for about 3 seconds: the light comes on in the programme progress display. To remove it press buttons SPIN SPEED and again until the light comes off. Selection of the DELAY START option To delay starting of a programme, press the DELAY START button before starting the machine. The figures corresponding to the selected delay will be displayed for about 3 seconds, after which the duration of the selected programme will appear on the display. If button (SOAK) has been pressed the selected delay will correspond to the soak time. If no delay time is selected the soak programme will last about 30 minutes. When the START/PAUSE button is pressed, the selected delay will appear again on the display and the machine starts its countdown. 15 23 How to wash Starting the programme 1. Press START/PAUSE to start the programme. If the Delay Start option has been selected the programme will start at the end of the countdown. If the DOOR light is green and flashing for some seconds and when it goes out the END light starts flashing, the alarm code E40 appears in the display, it indicates that the door is open. Close the door and press the START/PAUSE button again. If the delay start option has been selected, the machine starts its countdown, in hours, which will appear on the display. During this period it is possible to load other laundry, to cancel the delay time. · Load other laundry: press the START/PAUSE button. Close the door and press the START/PAUSE button again. · Cancel the delay time: press the START/PAUSE button. Press the DELAY START button until 0' appears on the display. Press the START/ PAUSE button again. Programme progress display By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on. After the machine has started, only the running phase pilot light stays on. Display The time to the end of the programme decreases minute by minute and appears on the display. 24 How to wash At the end of the programme The machine stops automatically. The END light comes on in the programme progress display. The START/PAUSE button is off, the DOOR light is green. If the light (OVERDOSAGE) comes on it indicates that too much detergent has been used. [. . . ] · Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine. · If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel (85x57 cm) covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances; · The machine must not be installed in rooms where the temperature can drop below 0. · The water inlet hose and the drain hose must not be kinked. · Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown. Levelling Carefully level by screwing the adjustable feet in or out. [. . . ]