User manual AEG-ELECTROLUX L14800

[. . . ] 132999111. qxd 7/24/01 11:16 PM Pagina 1 (Nero/Process Black pellicola) ÖKO-LAVAMAT 16800 LAVAMAT 14800 TURBO ELECTRONIC The environmentally friendly washer-dryer Instruction booklet ÖKO_LAVAMAT TURBO PREWASH 1600 1200 START/PAUSE DRYING TIME PREWASH WASH RINSES EXTRA RINSE SPIN DRYING DELAYED START END OVERDOSAGE SHORT SPIN LONG SPIN DRAIN SOFTENERS RINSES COLD 95 COTTONS LINENS ECONOMY SOAK QUICK WASH 900 700 400 RINSE HOLD STORE DRY IRON DRY 60 50 40 30 DRYING WOOL 30 40 COLD 16800 STAIN 30 40 40 40 60 50 SYNTHETICS EASY TO IRON DELICATES DRYING AUS ERFAHRUNG GUT 132999111. qxd 7/24/01 11:16 PM Pagina 2 (Nero/Process Black pellicola) Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. This symbol guides you, step by step, in the operation of the appliance. [. . . ] · Load other laundry: press the START/PAUSE button. Close the door and press the START/PAUSE button again. · Modify or cancel the delay time: press the START/PAUSE button. Press the DELAYED START button until the time required appears on the display, or 0h, if you wish to cancel it. Press the START/ PAUSE button again. Programme progress display By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on. After the machine has started, only the running phase pilot light stays on. PREWASH WASH RINSES EXTRA RINSE SPIN DRYING END OVERDOSAGE Display The time to the end of the programme decreases minute by minute and appears on the display. 28 132999111. qxd 7/24/01 11:16 PM Pagina 29 (Nero/Process Black pellicola) How to wash At the end of the programme The machine stops automatically. The END light comes on in the programme progress display. If the OVERDOSAGE light comes on it indicates that too much detergent has been used. At the next wash carefully follow the detergent manufacturer's instructions. Measure out detergent according to amount, type, degree of soil of fabrics and water hardness. This light could come on also when the drain filter is blocked. If the RINSE HOLD option has been selected, the water must be emptied out before opening the door either - by pressing the START/PAUSE button (the laundry will be spun at the speed corresponding to the selected type of fabrics. The spin speed can be reduced by means of the SPIN SPEED button) - or by turning the selector dial to O and then to DRAIN and pressing the START/PAUSE button again. In this case the water will be emptied, but the laundry is not spun. Check that the drum is empty so as to avoid any forgotten items being damaged in a subsequent wash (e. g. shrinking) or their colour running into a load of whites. Leave the door open to prevent the formation of mildew and unpleasant smells. 29 132999111. qxd 7/24/01 11:16 PM Pagina 30 (Nero/Process Black pellicola) How to wash Automatic washing and drying (NON-STOP programme) Warning!For NON-STOP programmes, it is also essential not to exceed the maximum load sizes of 2. 75 kg for cotton and 2 kg for synthetics. Do not use a dosing device when carrying out automatic washing and drying programme. Select the required options by means of the relevant buttons. If possible, do not select a spin speed lower than that proposed by the appliance to avoid a too long drying time so saving energy. When automatically washing and drying it is not possible to select a spin speed lower than 900 r. p. m. [. . . ] Should this occur, turn the water tap off and refer to your Service Force Centre to replace the hose. A Water drainage The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic "U-Piece" supplied. The standpipe should have an internal diameter of approximately 38 mm (see diagram) thus ensuring there is an air break between the drain hose and standpipe. 3 pin When discharging into a standpipe ensure that the top of the curve in the hose end is no more than 90 cm (35. 4") and no less than 60 cm (23. 6") above floor level. Max. 90 cm. (35. 4") The upright standpipe should have a minimum length of 30 cm (12") from the bottom of the elbow to the top of the pipe (see diagram). [. . . ]