User manual AEG-ELECTROLUX L50210

[. . . ] LAVAMAT 50210/50900 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Operating Instructions. [. . . ] Check the tap and have it repaired if necessary. Adjust the feet as described in the installation and connection instructions. The E (END) indicator flashes 1x. (Problems with water inflow) The filter in the screw connection on the inlet hose is blocked. Water tap is furred with lime scale or is faulty. The transportation lock has not been removed. The washing machine vibrates when operating The screw feet are not coror is not stable. rectly adjusted. 19 Problem Washing has not been spun. Possible cause Only a few large items of washing in the drum. Remedy Always load the drum as full as possible. Mix large and small items. Screw connection on the in- Screw the inlet hose on let hose is leaking. Water is running out Drain pump cover is not from under the washing closed properly. Too much detergent has probably been used. Maximum pumping height of 1m has been exceeded. (Problems with water outflow. ) Replace drain hose. Load washing carefully for the next wash. Close off emergency drain hose properly. Follow the manufacturer's instructions exactly when measuring out detergent. Remove any foreign objects from the pump housing. Drain pump is blocked. For sink spigot connections: Clean the sink spigot. Fabric softener not rinsed in, w compartment for conditioners is filled with water. Fabric softener insert in the Clean the detergent drawer, compartment for conditioninsert the fabric softener ers is not correctly inserted insert firmly. or is blocked. 20 Problem Possible cause Remedy Wait until the K (DOOR) indicator has gone out and the E (END) indicator is illuminated. The programme will continue when the power cut is over. To remove washing: If water can be seen in the appliance, first drain the water before opening the door (see section "Carrying out an emergency drain"). Observe maximum loads. Door locked. The door cannot be opened when the washing machine is switched There has been a power cut. (All indicators are off. ) The door will remain locked for approx. [. . . ] When draining into a wash basin or a bath, secure the drain hose with the supplied elbow to stop it slipping. Otherwise the water running out can force the hose out of the basin. When pumping the water out, check that the water is running away fast enough. Pumping heights over 1 m The washing machine's drain pump is able to pump water to a height of 1meter, calculated from the surface on which the appliance is installed. If pumping height is over 1 metre, malfunctions and damage to the appliance may arise. [. . . ]