User manual AEG-ELECTROLUX L50610

[. . . ] LAVAMAT 50610 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Operating Instructions. [. . . ] Close door until the catch audibly latches. Press the (START/ PAUSE) button for longer. Child safety device has been Deactivate the child safety activated. The door is not closed prop- Close the door properly. Unscrew the hose, remove the filter and clean it. Check the tap and have it repaired if necessary. Adjust the feet as described in the installation and connection instructions. The (END) indicator flashes 1x. (Problems with water inflow) The filter in the screw connection on the inlet hose is blocked. Water tap is furred with lime scale or is faulty. The transportation lock has not been removed. The washing machine vibrates when operating The screw feet are not coror is not stable. rectly adjusted. 19 Problem Washing has not been spun. Possible cause Only a few large items of washing in the drum. Remedy Always load the drum as full as possible. Mix large and small items. Screw connection on the in- Screw the inlet hose on let hose is leaking. Water is running out Drain pump cover is not from under the washing closed properly. Too much detergent has probably been used. Maximum pumping height of 1m has been exceeded. (Problems with water outflow. ) Replace drain hose. Load washing carefully for the next wash. Close off emergency drain hose properly. Follow the manufacturer's instructions exactly when measuring out detergent. Remove any foreign objects from the pump housing. Drain pump is blocked. For sink spigot connections: Clean the sink spigot. Fabric softener not rinsed in, w compartment for conditioners is filled with water. Fabric softener insert in the Clean the detergent drawer, compartment for conditioninsert the fabric softener ers is not correctly inserted insert firmly. or is blocked. 20 Problem Possible cause Remedy Wait until the (DOOR) indicator has gone out and the (END) indicator is illuminated. [. . . ] Always use the hose supplied with the appliance. Installation should comply with local water authority and building regulations' requirements. A minimum water pressure of 0. 05 MPa (0. 5 bar) is required for safe operation of the appliance. If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. [. . . ]