User manual AEG-ELECTROLUX L51MWL

[. . . ] Model L51M Important safety information These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the information in this book contact the Customer Care Department. All packaging, both inside and outside the appliance must be removed before the appliance is used. [. . . ] Any spillage on the stainless steel finish must be wiped off immediately. Do not attempt to remove any of the control knobs from the appliance as this may cause damage and is a safety hazard. Cleaning the control knobs and handles It is strongly recommended that only hot soapy water is used for cleaning the control knobs and handles. ANY OTHER CLEANING MATERIALS MAY DULL THE SURFACE FINISH. 19 Cleaning the hob Clean the hotplate top using a mild abrasive. Take care not to damage the spark electrodes. If the spark electrodes are damaged the burners will not light. You can remove the pan supports, burner caps and burner crowns to clean them. Again take care not to damage the spark electrodes. Clean the burner crowns and pan supports by soaking them in very hot soapy water. Aluminium based saucepans can leave shiny metal marks on the pan supports. You can remove any stubborn stains by scouring with a soap impregnated steel wool pad. If you look after the burner crowns and pan supports in this way they will stay reasonably clean. However the surface will dull with time. After cleaning the appliance parts, dry them thoroughly before you put them back. When replacing hotplate burner parts 1. (Do not try to force the crown on to the body). Make sure that the hole in the crown is over the electrode. Check that the location pegs sit in the slots in the body. When the crown is in this position let it fall freely on to the body. Check that the crown can be moved slightly from side to side. 2. Place cap centrally on the top of crown (enamel side up). Move sideways and front to back to check the cap is properly fitted. If a burner will not light then you need to check the crown and cap positions. [. . . ] The pressure should be either:(i) For Natural Gas 20mbar (ii) For LP. The pressure must be set to 28 mbar for use on butane or 37 mbar for use on propane. 33 4. Turn off the taps, disconnect the pressure gauge and replace oven burner and cover, ensuring that the F. S. D phial is correctly located into the bracket on the burner. Check operation of the oven. Turn off the hotplate and wait 1 minute. Turn the hotplate control knob to large flame symbol (highest setting). [. . . ]