User manual AEG-ELECTROLUX L52810

[. . . ] LAVAMAT 52810 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Operating Instructions. [. . . ] Water tap is blocked with limescale or faulty. The transport lock has not Removing the transport lock. The washing machine vibrates when operating Adjust the feet as described The screw feet not correctly or is not stable. nection instructions. 22 Problem Washing has not been spun. Possible cause Only a few large items of washing in the drum. Remedy Always load the drum as full as possible. Mix large and small items. Screw connection on the inTighten inlet hose. Water is leaking out un- Drain pump cover is not derneath the washing closed properly. Washing water is foam- Probably too much detering excessively. (Problems with water outflow. ) Replace drain hose. Load washing carefully for the next wash. Close off emergency drain hose properly. Dose detergent exactly as instructed by manufacturer. Please contact Customer Care Department. Remove foreign bodies from pump housing. Clean sink outlet. Drain pump is blocked. With connection to sink outlet: sink outlet is blocked. Fabric softener not rinsed in, w compartment for additives is filled with water. Conditioner insert in the compartment for additives is not correctly attached or is blocked. Door locked. Clean detergent dispenser drawer, insert conditioner insert firmly. Wait until DOOR light goes off and END light comes on. Programme continues, when power cut is over. To remove washing: If water can be seen in the appliance, before opening the door, first drain off the water. (See section "Carrying out an emergency drain". ) Observe maximum loads. Door cannot be opened Power cut. (All display indiwhen appliance is cators are off. ) switched on. 2 minutes. Washing is heavily creased. Possibly too much washing was loaded. 23 If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum Too little detergent is being used. [. . . ] Otherwise the water running out can force the hose out of the basin. When pumping the water out, check that the water is running away fast enough. Pumping heights over 1 m The washing machine's drain pump is able to pump water to a height of 1meter, calculated from the surface on which the appliance is installed. If pumping height is over 1 metre, malfunctions and damage to the appliance may arise. For pumping heights over 1metre a conversion kit can be obtained. [. . . ]