User manual AEG-ELECTROLUX L60210

[. . . ] LAVAMAT 60210 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Operating Instructions. [. . . ] The washing machine vibrates when operating Adjust the feet as described The screw feet not correctly or is not stable. Only a few large items of washing in the drum. Always load the drum as full as possible. Mix large and small items. Screw connection on the in- Screw the inlet hose on let hose is leaking. Water is running out Drain pump cover is not from under the washing closed properly. At the Probably too much deterend of the washing cy- gent has been used. indicator (END) flashes 2x, at the same time an acoustic signal sounds 2x. (Problems with water outflow) Maximum pumping height of 1m exceeded. Load washing carefully for the next wash. Close off emergency drain hose properly. Follow the manufacturer's instructions exactly when measuring out detergent. Please contact the Customer Care Department. Remove foreign bodies from the pump housing. Drain pump is blocked. For sink spigot connections: Clean the sink spigot. Conditioner not rinsed in, w compartment for additives is filled with water. Conditioner insert in the compartment for additives is not correctly attached or is blocked. Clean the detergent drawer, insert the conditioner insert firmly. 20 Problem Possible cause Door locked. Remedy Wait until indicator (DOOR) is lit green. The programme will continue when the power cut is over. To remove washing: If water can be seen in the appliance, before opening the door, first drain off the water. (See section "Carrying out an emergency drain". ) Observe maximum loads. The door cannot be opened when the wash- There has been a power cut. ing machine is switched (All indicators are off. ) For safety reasons, the door on. 4 to 10 minutes. Washing is heavily creased. Possibly too much washing was loaded. If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum Too little detergent is being used. Programme or temperature was not correctly set. [. . . ] When draining into a wash basin or a bath, secure the drain hose with the supplied elbow to stop it slipping. Otherwise the water running out can force the hose out of the basin. When pumping the water out, check that the water is running away fast enough. Pumping heights over 1 m The washing machine's drain pump is able to pump water to a height of 1meter, calculated from the surface on which the appliance is installed. If pumping height is over 1 metre, malfunctions and damage to the appliance may arise. [. . . ]