User manual AEG-ELECTROLUX L60890

[. . . ] The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. This symbol guides you, step by step, in the operation of the appliance. The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. Tips and information about economical and ecological use of the machine are marked with the clover symbol. [. . . ] Follow the manufacturer's instructions. The quantity of detergent can then always be adjusted to degree of hardness I (= soft). Information on water hardness can be obtained from your local water supply authority. Information on water hardness Degree of hardness I=Soft II=Medium III=Hard IV=Very hard German degrees °dH French degrees °TH 0-7 7-14 15-21 more than 21 0-15 16-25 26-37 more than 37 60 Preparing the wash cycle How to wash Load the laundry Open the door. Place the laundry in the drum, one item at a time. Distribute laundry as evenly as possible. Close the door. Add detergent and additives Pull the drawer out till it stops. Pour the main wash detergent into compartment . If you wish to perform a PREWASH pour detergent into compartment . If you wish to perform a STAIN pour the Stain Remover into compartment . Do not use normal detergent for the STAIN-Action programme, always use a STAIN remover. * Pour the fabric softener into compartment without exceeding the "MAX" mark. Close the drawer gently, pushing it fully in. 61 How to wash Select the desired wash programme Turn the programme selector dial to the desired position: the lights corresponding to the different phases making up the selected programme light on. · Cancel the delay time: press the START/PAUSE button. Press the DELAY START button until the symbol 0' appears on the display. Press the START/ PAUSE button again if you wish to restart the programme. Programme progress display By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on. After the machine has started, only the running phase pilot light stays on. PREWASH/ WASH RINSES EXTRA RINSE SPIN END OVERDOSAGE PRELAVADO/ LAVADO ACLARADO ACLARADO + CENTRIFUGAR FIN SOBRE DOSIF. DOOR PUERTA Display The time to the end of the programme decreases minute by minute and appears on the display. 64 How to wash At the end of the programme The machine stops automatically. The FIN (END) light comes on in the programme progress display, the START/PAUSE button goes off and the light PUERTA is green. If the RINSE HOLD option has been selected, the START/PAUSE button goes off, the pilot light END on the programme progress display illuminates, the light PUERTA is red and the display shows a static zero to indicate that the water must be emptied out. To empty out water there are two possibilities: · Select programme DESAGUAR (draining): The water is emptied out without spinning. · Select programme CENTRIFUGAR (spin) or CENTRIF. Select the spin speed by means of the relevant button and then depress the START/PAUSE button. The water is emptied out and the laundry is spun at the selected spin speed. The programme selector dial must be turned first to RESET O/OFF and then to the DRAIN programme DESAGUAR, CENTRIFUGAR (spin) or CENTRIF. [. . . ] Connect the hose with the angled connection to the machine. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent HEC0006 leaks. [. . . ]