User manual AEG-ELECTROLUX L76810

[. . . ] LAVAMAT 76810 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Operating Instructions. [. . . ] Unscrew the The filter in the threaded inhose, take out the filter and let hose fitting is blocked. Water tap is furred with lime scale or is faulty. Check the tap and have it repaired, if necessary. 19 Problem Possible cause Remedy Removing the transit packaging. Adjust the feet as described in the installation and connection instructions. Always load the drum as full as possible. Mix large and small items. The transport lock has not been removed. The washing machine vibrates when operating The screw feet not correctly or is not stable. Only a few large items of washing in the drum. Screw connection on the in- Screw the inlet hose on let hose is leaking. Water is running out from under the washing machine. Drain pump cover is not closed properly. At the end of the washing cycle, the spin stops. Load washing carefully for the next wash. Close off emergency drain hose properly. Too much detergent has probably been used. Follow the manufacturer's instructions exactly when measuring out detergent. Kink in drain hose. The END indicator flashes 2x, and an acoustic signal sounds 2x. (Problems with water inflow. ) Do not exceed the maximum pump height of 1m. Straighten the hose. Remove foreign bodies from the pump housing. Drain pump is blocked. For sink spigot connections: Clean the sink spigot. Fabric softener was not rinsed in, the compartment w for conditioners is full of water. Fabric softener insert in the Clean the detergent drawer, compartment for conditioninsert the fabric softener ers is not correctly attached insert firmly. or is blocked. 20 Problem Possible cause Door locked. Remedy Wait until the DOOR indicator is illuminated green. The programme will continue when the power cut is over. To remove washing: If water can be seen in the appliance, first drain off the water before opening the loading door (see section "Carrying out an emergency drain"). Observe maximum loads. The door cannot be opened when the wash- There has been a power cut. [. . . ] When draining into a wash basin or a bath, secure the drain hose with the supplied elbow to stop it slipping. Otherwise the water running out can force the hose out of the basin. When pumping the water out, check that the water is running away fast enough. Pumping heights over 1 m The washing machine's drain pump is able to pump water to a height of 1meter, calculated from the surface on which the appliance is installed. If pumping height is over 1 metre, malfunctions and damage to the appliance may arise. [. . . ]