User manual AEG-ELECTROLUX LAV 74620-W

[. . . ] ÖKO-LAVAMAT 74620 update The environmentally friendly washing machine Instruction book Dear customer, Please read these user instructions carefully. Above all, observe the "Safety" section in the first pages. Keep these user instructions in a safe place for future reference. Please pass them along to future owners of the appliance. [. . . ] Press the door firmly in the area of the lock. Adjust the feet as per the installation and connection instructions. Washing machine vibrates during operation or is unstable. There is only very little washing in the drum (e. g. Water could not be completely pumped out prior to spinning because the drain hose is kinked or the circulation pump is blocked. Check the drain hose and if necessary remove any kink or clean the circulation pump and remove any foreign bodies from the pump housing. Excessive foaming during the main wash Dose detergent exactly in Probably too much detergent accordance with the manuwas used. Threaded fitting on the water inlet hose is leaking. Check drain hose and if necessary replace. Stop the program, remove washing from the door, start a new program. Clean detergent drawer, place suction cap firmly in position. Water runs out from under the washing machine. Circulation pump cover is not closed properly. Washing is trapped in the door. Washing is creased. Conditioner is not washed in, the À compartment for conditioner is full with water. Too much washing was placed in the appliance. Suction cap in the compartment for conditioner is not correctly positioned or is blocked. 31 Operating instructions Malfunction Possible Cause Drain hose is kinked. Maximum pumping height (drain height 1m above the floor on which the machine is standing) exceeded. In the case of siphon connection: siphon is blocked. Door cannot be opened The door is locked for safety when the machine is reasons. Please contact customer service who have a retrofit kit for pumping to heights of greater than 1m. Switch off the machine and unplug from the mains, clean the circulation pump. Clean siphon. Washing is not spun properly, water is still visible in the drum. Error code (2 is displayed. Wait until the (DOOR) indicator is green. Open tap fully. The sieve in the threaded fitRemnants of detergent ting on the water inlet hose Clean sieve. are building up in the at the tap is blocked. Sieve on threaded fitting for the water inlet hose on the Clean sieve. When an additional program button is pressed, the corresponding indicator does not illuminate. [. . . ] Box 4101 King Abdul Aziz Street Riyadh Tel. : 4645977 Al Nahas Est. Box 1 15 29 Jeddah Tel. : 6606852 Slovenia Electrolux Slovenia D. O. O. 132 1000 Ljubljana Tel. : 61 1234 137 Fax: 61 1234 238 Singapore Japan Arzbergh Engineering Electrolux Japan Ltd. Yasuda Warehouse 4F 3-3-12 19 Tanglin Road 06-07 Singapore 247909 Heiwajima Ota-Ku Tel. : 65 7356572 Tokyo Fax: 7351124 Tel. : 81 3 3544 3363 Fax: 81 3 3763 6143 Thailand OLYMPIA Thai Ltd. [. . . ]