User manual AEG-ELECTROLUX LAV 86700-W GB

[. . . ] ÖKO-LAVAMAT 86700 update The environmentally friendly washing machine Operating instructions Dear customer, Please read these operating instructions through carefully, before using the appliance. Please ensure you fully understand the safety instructions on the first pages of these operating instructions!Retain the operating instructions for future reference, and pass them on to any future owners. 1 The warning triangle and/or the key words (Warning!, Caution!, Important!), emphasizes information which is important for your safety or the correct functioning of the appliance. It is essential that this information is observed. [. . . ] 0 Push the compartment in completely. 23 Run wash cycle Starting the washing program 0 Check the water tap is open. 0 Start the washing program: Press START/PAUSE button. The washing program will start, or starts after the delay time set has expired. 3 If the DOOR/LIGHT display is flashing red when the START/PAUSE button is pressed, the door is not correctly closed. Firmly close the door and press the START/PAUSE button again. With the delay timer set: With the delay time set the multi-display shows the remaining time, in hours, until the start of the wash program. During this time, you can add washing or change or cancel the delay timer. · Adding washing: press the START/PAUSE button, this enables the door to be opened. Then close the door and press the START/PAUSE button again. · Changing or cancelling the delay timer: press the button repeatedly until the time desired is displayed; if the program running time is displayed (such as 110) the washing program will start immediately. During the washing program Before the start the selected program steps are displayed by the program progress display. During the washing program the current program step is shown. The remaining wash time until the end of the program is continuously displayed in the multidisplay in minutes. During a washing program the spin speed can still be changed or RINSE HOLD can still be set. With the START/PAUSE button, the washing program can be interrupted at any time and continued by pressing the button again. The washing program can not be changed during the pause. To change or stop the washing program, turn the program selector to the OFF position. 24 Run wash cycle End of wash cycle/Removing the washing 0 If RINSE HOLD was selected: After a rinse hold, the water has to be pumped out: ­ Either press the START/PAUSE button (the washing is spun in accordance with the program which has just finished; the final spin speed can be changed whilst the washing is being spun using the spin speed button), or ­ turn the program selector to PUMP OUT and press the START/PAUSE button (the water is pumped out without the washing being spun), or ­ turn the program selector to SPIN or SHORT SPIN and press the START/PAUSE button (the washing is spun or spun gently). After this program step has been completed the END lamp is illuminated. as soon as the display next to the DOOR/LIGHT button is green the door can be opened (not when the child safety device is activated, please refer to "Child safety device"), Turn the program selector to OFF. After the program has finished, pull the detergent drawer out a little so that it can dry. This helps to prevent stagnent smells and helps to preserve the door seal. If the OVERDOSING display lights up it shows that too much washing powder was used in the washing program which has just run. For this reason an extra rinse was carried out. Check the dosage instructions of the detergent manufacturers. 0 0 0 0 3 25 Program tables Washing The following tables list the most commonly used and most useful programs. Type of washing, care label Max. [. . . ] The guarantee does not cover commercial use. The guarantee covers all parts or components which fail due to faulty workmanship or faulty materials. The guarantee does not cover appliances where defects or poor performance are due to misuse, accidental damage, neglect, faulty installation, unauthorised modification or attempted repair, commercial use or failure to observe requirements and recommendations set out in the instruction book. This guarantee does not cover such parts as light bulbs, removable glassware, dust bags or filters. [. . . ]