User manual AEG-ELECTROLUX LAV 86800-W

[. . . ] ÖKO-LAVAMAT 86800 update The environmentally friendly washing machine Operating instructions Dear customer, Please read these operating instructions through carefully. Please make sure you read the safety instructions on the first pages of these operating instructions!Keep the operating instructions for future reference. Pass them on to any future owners. 1 With the warning triangle and/or by means of key words (Danger!, Caution!, Attention!), information is emphasized which is important for your safety or the correct functioning of the appliance. [. . . ] 0 Set washing program and temperature: set the program selector to the desired washing program with the desired temperature. The selected program/ the selected program group is illuminated. The duration of the program set is displayed in the Multidisplay in minutes. 0 If necessary select additional program(s): The additional program selected is illuminated. · To change the selection press another button. · To delete the selection press the button again. 3 0 If necessary select the spin speed for the final spin: press the SPIN button as many times as required until the desired spin speed appears in the display. When the displays shows "0" the washing is left in the last rinse water, it is not spun (rinse hold). 0 If necessary set the time delay: press the TIME DELAY button as many times as required until the desired delay is displayed, this is shown in the form 12h for a 12 hour delay to the start of the program. 3 If 19h is displayed and you press again, the duration of the washing program set appears (display without h !). In the case of SOAKING, the time delay defines the soaking period. (Without time delay the soaking time is approx. 1 hour. ) 22 Run wash cycle Fill-in the laundry 0 Sort and prepare washing according to type. For notes on the correct preparation of the washing, see "Washing Types and Care Symbols". 0 Fill the washing. 3 3 For maximum load, see "Program Tables". 0 Close the door tightly. Do not trap any washing when closing the door!The fabrics and the machine could be damaged! 23 Run wash cycle Add detergent/conditioner 0 Open the drawer: reach inside the flap on the bottom of the drawer, pull the drawer out to the stop. 0 Fill in detergent/conditioner. 3 For notes on detergent and conditioner, see "Detergent and Conditioner". k Pre wash detergent/detergent for soaking (for additional program PRE WASH/SOAKING), or water softener l Powdered main wash detergent (If you use water softener and need compartment k for pre wash detergent/detergent for soaking, put the water softener on top of the main wash detergent in compartment l . ) m Stain remover (only for the STAIN program) w Liquid conditioner (softener, finisher, starch). Attention!Fill the compartment at the most up to the MAX mark. Thick liquid detergents are eventually diluted up to the MAX mark, powdered starch is dissolved. 0 Push in the compartment quite inside. 24 Run wash cycle Start washing program 0 Check whether the water tap is opened. 0 Start washing program: press START/PAUSE button. The washing program is started or starts at the end of the delay time set. 3 If DOOR/LIGHT flashes red when START/PAUSE is pressed, then the door is not closed properly. Close the door firmly and press the START/PAUSE button again. [. . . ] The door cannot be opened with the DOOR/LIGHT button. Also after the washing cycle has finished you first have to deactivate the program lock before you can open the door. Deactivating the program lock: 0 Keep the PRE WASH and SOAKING buttons pressed simultaneously for five seconds. The program progress display flashes for five seconds, after this it lights up continuously for five seconds; the program lock is deactivated. If the program selector is altered during a washing cycle, with the program lock activated, the program progress display flashes: 0 If this happens turn the program selector back to its original position. [. . . ]