User manual AEG-ELECTROLUX LAV2060UGB

[. . . ] Switching on the appliance/selecting a programme . Changing spin speed/selecting rinse hold . Interrupting a programme/adding washing . Washing cycle complete/removing the washing . [. . . ] Fabric softener not rinsed in, w compartment for additives is filled with water. Conditioner insert in the compartment for additives is not correctly attached or is blocked. Clean detergent dispenser drawer, insert conditioner insert firmly. 19 Problem Possible cause Door locked. Remedy Wait until DOOR light goes off and END light comes on. Programme continues, when power cut is over. To remove washing: If water can be seen in the appliance, before opening the door, first drain off the water. (See section "Carrying out an emergency drain". ) Observe maximum loads. Door cannot be opened Power cut. (All display indiwhen appliance is cators are off. ) switched on. 2 minutes. Washing is heavily creased. Possibly too much washing was loaded. If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum · Too little detergent is being used. · The right detergent was not used. · Special soiling was not pre-treated. · Programme or temperature was not correctly set. · Washing soiled with ointment, grease or oil was washed with too little detergent. It is only necessary to open the pump cover if there is a malfunction and water is no longer being pumped out, e. Please make sure before loading the washing that there are no foreign bodies in the pockets or caught between the washing. that may have got into the washing machine with the washing remain in the pump housing (foreign body trap that protects the pump wheel). 1 Warning!Before opening the pump cover, switch off the washing machine and remove the mains plug from the socket. Place a cloth on the floor in front of the drain pump cover. Unscrew the pump cover in an anticlockwise direction and remove it. 4. Remove foreign bodies and fluff from the pump housing and from the pump wheel. 5. Check whether the pump wheel right at the back of the pump housing can turn. (It is normal for the pumping wheel to turn jerkily. ) If the pumping wheel cannot be turned, please contact the Customer Care Department. Insert the guides at the sides of the cover into the guide slots and tighten the cover by turning in a clockwise direction. Close off the emergency drain hose and place it in the support. [. . . ] Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: · a chemical or electrochemical reaction caused by water, · abnormal environmental conditions in general, · unsuitable operating conditions, · contact with harsh substances. [. . . ]