User manual AEG-ELECTROLUX LAV2080

[. . . ] · Check the electricity supply is the same as that indicated on the rating plate of the appliance. · Should the appliance mains cable need to be adapted for any reason this should only be carried out by a qualified/competent person. · In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the electrical regulations. · The switch must not break the yellow and green earth cable at any point. [. . . ] · The appliance is heavy, care must be taken when moving it. 17 Appliance Installation Removing Transit Packaging · Ensure all transit packaging is removed prior to installation. · Retain transit packaging for future use. F G E A C C B D B H 3 0 0 0 0 0 0 0 The appliance is supplied with a spanner (H) and plastic caps (E) (2 pcs. ) and (G) (1 pc). Remove the 2 screws (B) with the spanner supplied (H). Cover the holes left by screws (B) the 2 plastic caps (E). Replace the 4 screws (C), for safe keeping. Remove the screw and compression spring (F) with the spanner (H), cover the hole with plastic cap (G). Important: When fitting the plastic caps, press until they snap into the rear panel securely. 18 Appliance Installation Installation-Site Preparation · The installation surface must be clean, dry and level. · Do not install on deep pile carpet. · If the appliance ist installed next to heat source (e. cooking appliance), a heat insulating pad (85 x 57 cm) must be placed between the washing machine and the heat source. · Do not install the appliance in locations where the temperature may fall below freezing. · The wire coloured brown must be connected to the terminal marked "L" or coloured red. · Upon completion there must be not cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. 1 WARNING: A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely. Permanent connection In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point. ; This appliance is in accordance with the following EU Guidelines: ­ Low Voltage Guidelines 73/23 EEC dated 19 February 1973, include Guideline Change Notice 93/68 EEC ­ EMC Guideline 89/336 EEC dated 3 May 1989, including Guideline Change Notice 92/31 EEC. This appliance complies with the requirements laid out in the EEC Directive 76/899. Voltage 240 V AC Fuse rating 13 amps See rating plate for further information. Particular regulations of local electricity authorities must be observed. This appliance conforms to EEC Directive No. 82/499/EWG on radio interference. 1 WARNING: Repairs to electrical appliances may only be performed by trained personnel. Improper repairs may lead to serious risks for the user. 21 Water Connection 3 The washing machine is provided with safety devices preventing backcontamination of the water supply and complies with local water authority requirements. [. . . ] If a longer inlet hose is required contact your AEG Service Force Centre. Under no circumstances should hoses be connected together to provide a longer length. The rubber washers are either set into the inlet hose threaded connection or supplied separately in the installation kit. These washers must be fitted to ensure water tight seals. [. . . ]