User manual AEG-ELECTROLUX LAV50420-W

[. . . ] LAVAMAT 50720 Washing machine Instruction book Dear Customer, Please read this instruction book through carefully, before using the appliance. Please ensure you fully understand the safety instructions on the first pages of this instruction book!Retain the instruction book for future reference, and pass it on to any future owners. The warning triangle and/or the key words (Warning!, Caution!, Important!), emphasizes information which is important for your safety or the correct functioning of the appliance. [. . . ] Do not use household furniture polish or abrasive cleaners to clean the panel and operating parts. Wipe over the operating panel with a damp cloth. Use warm water. 0 Detergent Dispenser Drawer The detergent dispenser drawer should be cleaned from time to time. Pull the detergent dispenser drawer out as far as it will go. Remove the detergent dispenser drawer by pulling sharply. Clean the suction cap under running water. Clean the separate compartments with warm water. Push on the suction cap firmly so that it is sitting tightly. Clean the entire compartment area of the washing machine with a brush. Set the detergent dispenser drawer into the guide tracks and push in. Washing Machine Drum The washing machine drum is made from rust-free stainless steel. Any objects left in the laundry which are likely to rust can stain the drum. Do not clean the stainless steel drum with descaling agents containing acids, scouring agents containing chlorine or iron or steel wool. AEG Service Force Centre has suitable agents available. Remove rust stains on the drum with a stainless steel cleaning agent. 0 Door 0 Regularly check if there are deposits or foreign bodies in the rubber seal behind the door and remove them. 27 Operating Instructions What to do when. . . 3 The whistling noise when spinning may be different to your prevous washing machine which is due to the modern drive system. Trouble Shooting If you call out an engineer and the fault is listed here, a charge is levied even if the appliance is in guarantee. Malfunction Possible Cause Remedy Washing machine does Mains plug is not plugged in. Filter in the threaded fitting on the water inlet hose is blocked. Close door, lock must engage audibly Open tap. Unscrew the hose from the tap, remove the Filter and clean under running water Adjust the feet according to the installation and connection instruction. Washing machine vibrates during operation or is unstable. There is only very little washing in the machine (e. g. Water cannot be completely pumped out because the drain hose is kinked or the drain pump is blocked. Check the drain hose and if necessary remove any kink or clean the drain pump and remove any foreign bodies from the pump housing. It may be necessary to reduce the amount of deterExcessive foaming dur- Probably too much detergent gent used. was used gent manufacturer's recommendations. 28 Operating Instructions Malfunction Possible Cause Threaded fitting on the water inlet hose is leaking. Water runs out from under the washing machine. [. . . ] i. ): Unscrew the inlet hose from the appliance at the inlet solenoid valve and remove the flow regulator (to do this, remove the sieve with needle-nose pliers and remove rubber washer behind the sieve). Retain the washer for future use. Inlet Hose Connection The inlet hose provided is 1. 2 or 1. 3 metres depending on the model. If a longer inlet hose is required contact your AEG Service Force Centre. Under no circumstances should hoses be connected together to provide a longer length. [. . . ]