User manual AEG-ELECTROLUX LAV508

[. . . ] It is imperative that this information is observed. 0 1. This symbol guides you step by step through the operation of the appli- ance. . . . 3 2 Next to this symbol you will find additional information and practical tips on using the appliance. Tips and information on economical and environmentally responsible use of the unit are identified with the clover leaf. [. . . ] Disconnect the hose from the water tap, remove the filter and clean under running water. Check the water tap and have it repaired if necessary. The filter in the socket of the inlet hose is blocked. Water tap is blocked with limescale or is faulty. 28 Operating Instructions Problem Possible cause Remedy First turn the programme selector to I (OFF), then set the desired programme to the exact position. The L (END) light flashes 8 times and The programme selector has and an acoustic not clicked into place corsignal is emitted 8 rectly. times. Remove the transit packaging Transit packaging was not reas described in the Installation moved. The washing machine vibrates when There is very little washing in the drum (for example one operating, or is dressing gown). Water could not be fully drained out before spinning because the drain hose is kinked or the water pump is blocked. Adjust the feet according to the Installation and Connection instructions. This does not affect the operation of the machine. Check the drain hose and remove any kinks if necessary or clean the water pump and if necessary remove any foreign bodies from the pump housing. It may be necessary to reduce the amount of detergent used. Follow the detergent manufacturer's recommendations. Probably too much detergent has been used 29 Operating Instructions Problem Possible cause The screw connection of the inlet hose is leaking. The drain pump cover is not correctly closed. (For safety reasons, the door remains locked for around 2 minutes. ) If washing has to be taken out during a power cut: Turn the control knob to I (OFF). Carry out emergency emptying (see Section "Carry out emergency emptying"). After about 2 minutes, the door can be opened by pulling on the handle. Unscrew the inlet hose from the water tap and from the machine. Clean the filter. The door cannot be opened when the washing machine Door is locked due to high is on. water level, or high temperaO/s (START/ ture. PAUSE) and K (DOOR) lights come on. Power failure during a wash programme (all indicator lights are off). The water tap is not fully Remnants of deter- opened. gent are building up in the detergent The inlet hose filter in the in coupling of the inlet hose at drawer. When pressing a programme option button, the corresponding indicator does not light up. The cause is probably a deter- This has no negative effects on gent with a high silicate con- rinse results; use a liquid detent. tergent if necessary. The selected programme option cannot be combined with Make another selection. the set programme. 31 Operating Instructions If the washing results are not satisfactory If the washing has turned grey and if limescale is deposited in the drum, then Too little detergent was used. [. . . ] Box 1 15 29 Jeddah Tel. : 6606852 Slovenia Electrolux Slovenia D. O. O. 132 1000 Ljubljana Tel. : 61 1234 137 Fax: 61 1234 238 Japan Electrolux Japan Ltd. Domestic Appliances Department Maruzen Showa Warehouse Building Tookai 4-5-12, Ota-ku 143-006 Tokyo Tel. : 0120-13-7117 Fax: 03-3790-5257 Thailand OLYMPIA Thai Ltd. 44 Ratchadapisek Road 10320 Bangkok Tel. : 2 513 6111 Fax: 2 513 2574 Hungary Electrolux Lehel KFT (AEG Div) Erzsbet Kirlyn tja 87. [. . . ]