User manual AEG-ELECTROLUX LAV508A

[. . . ] Useful tips and hints Environmental information 2 Contents Operating Instructions. Switching on the appliance/selecting a programme . Changing the spin speed/selecting rinse hold . Interrupting a programme/adding washing . [. . . ] The maximum pump height of 1m has been exceeded. Follow the manufacturer's instructions exactly when measuring out detergent. Please contact your local Service Force Centre Switch off the appliance. Remove foreign bodies from the pump housing. The END indicator is flashing 2x. (Problems with the waThe drain pump is blocked. ter outflow. ) For sink spigot connections: Clean the spigot. the spigot is blocked. 19 Problem Conditioner has not been rinsed in, compartment w for conditioner is filled with water. Possible cause Remedy The conditioner insert in the Clean the detergent drawer, compartment for additives insert the conditioner insert has not been correctly infirmly. Wait until the DOOR indicator goes out and the END indicator illuminates. The programme will continue when the power cut has ended. To remove the washing: If water can be seen in the appliance, first empty the water before opening the door (see section "Carrying out an emergency drain"). Observe the maximum load volume. The door is locked. The door cannot be opened when the wash- There has been a power cut. Insert the plug firmly into the emergency drain hose and turn it in a clockwise direction until it is firmly in place. Replace the emergency drain hose into the retainer. Insert the plinth flap into place and close it. 21 Drain pump The drain pump is maintenance-free. It is only necessary to open the pump cover if there is a malfunction and water is no longer being pumped out, e. g. Before loading the machine, please always ensure that there are no foreign bodies present in the pockets or in between the items to be washed. which may find their way into the washing machine along with the washing will remain in the drain pump housing (foreign body trap that protects the pump wheel). 1 Warning!Before opening the cover of the drain pump, switch off the washing machine and remove the power plug from the power point. Place a cloth on the floor in front of the cover of the drain pump. Unscrew the pump cover in an anticlockwise direction and remove it. 4. Remove foreign bodies and fluff from the pump housing and from the pump wheel. 5. [. . . ] · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. · This guarantee is in addition to your statutory and other legal rights. [. . . ]