User manual AEG-ELECTROLUX LAV52665

[. . . ] LAVAMAT 54665 ELECTRONIC Washing Machine User information Dear Customer, Please read this user information carefully. Pay particular attention to the section "Safety" on the first Info pages. Please keep this user information in a safe place for later reference. Pass it on to any future owners of the unit. 1 The warning triangle and /or signal words (Warning!, Caution!, Important!) emphasise information which is important for your safety or for the unit's functional reliability. [. . . ] Follow the detergent manufacturer's recommendations. Probably too much detergent has been used 29 Operating Instructions Problem Possible cause The screw connection of the inlet hose is leaking. The drain pump cover is not correctly closed. Remedy Tighten the inlet hose screw connection. Check the drainage hose and replace if necessary. Close the cover correctly. Water leaks out Stop the programme, remove of the washing maWashing is caught in the door. Close the emergency emptying hose (see Section "Carry The emergency emptying hose out emergency emptying"). is not correctly closed or is Call your local Service Force leaking. Centre if the emergency emptying hose is leaking. Fabric softener was The insert in the conditioner not rinsed in, the compartment is not correctly compartment is attached or is blocked. Clean the detergent dispenser drawer and attach the conditioner insert correctly. Pay attention to the maximum load quantity (see Programme Tables). In the case of easycare fabrics, select the < (EASY IRON) programme. Always load the drum as ful as possible with a combination of large and small items. Contact your local Service Force Centre. For pumping heights over 1 m a conversion kit is available as a special accessory. Switch off the machine and disconnect the mains plug. Clean the siphon. Washing is heavily creased. Probably too much washing has been put in the drum. The washing has not been spun as dry as usual. The washing was not able to be distributed evenly in the drum prior to spinning. The drain hose is kinked. Washing is not thoroughly spun, water remains visible in the drum. The L (END) light flashes twice, an acoustic signal is emitted twice. The maximum pump height (outlet height 1 m from the base of the appliance) is exceeded. The drain pump is blocked. For siphon attachments: the siphon is blocked. 30 Operating Instructions Problem Possible cause Remedy Wait until the programme has ended, the K (DOOR) light goes off and the L (END) light is lit. If it is necessary to open the door immediately, Turn the programme selector to I (OFF); then turn it to v (DRAIN). When the water has been pumped out, the door can be opened. [. . . ] 1142 Budapest Tel. : 00361/467-3200 Singapore Arzbergh Engineering 19 Tanglin Road 06-07 Singapore 247909 Tel. : 65 7356572 Fax: 7351124 Slovakia Rep. Seberiniho 1 821 03 Bratislava Tel. : 02 4333 4322, 4355 Fax: 02 4333 6976 USA ANDI Co. East 65 Campus Plaza Edison, New Jersey 0837 USA/Tel. : (201) 2258839 South Africa AEG (Pty) Ltd. Box 1 02 64 Kew/Johannesburg 2000 Tel. : 8069111 Syria Masri & Shami P. O. [. . . ]