User manual AEG-ELECTROLUX LAV561

[. . . ] This symbol guides you step by step in operating the unit. 2. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentally-responsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". [. . . ] Push on the softener insert as far as it will go so that it is secure. 33 Instructions for use 7. Use a brush to clean the entire rinsing-in part of the washing machine, especially the nozzles on the top side of the rinsing-in chamber. 8. Insert the washing detergent drawer into the guide rails and push it in. Washing Drum The washing drum is made of high-quality stainless steel. Rust deposits on the drum can occur due to foreign bodies in the washing which can cause rust. Do not clean the stainless steel drum with acidic antiliming agents, scouring agents containing chlorine or iron or steel wool. Our Customer Service Department has suitable agents available. Remove any rust deposits on the drum using a stainless steel cleaning agent. 0 Filling Door 0 Check regularly whether there are deposits or foreign bodies in the rubber sleeve behind the filling door and, if so, remove them. 34 Instructions for use Cleaning the drain pump Paper clips, nails and so on can sometimes get into the washing machine with the washing and remain in the drain pump casing. Fluff and strands of fabric can gather on these items and block the drain pump. Therefore the drain pump should be cleaned at least once a year. Switch off the washing machine and pull out the mains plug before cleaning the drain pump!First carry out an emergency emptying (see section "Carry Out Emergency Emptying"). The transport locks have not been removed. Unscrew the hose from the stopcock, remove the filter and wash it under running water. Check the stopcock and have it repaired if necessary. Remove the transport locks as described in the Installation and Connection instructions. Adjust the feet as described in the Installation and Connection instructions. The height-adjustable feet have not been set correctly. The washing machine vibrates when operating or is not still. There is not very much washThe operation of the appliing in the drum (e. g. Water has not been able to be drained completely before spinning because the outlet hose has a kink in it, or the drain pump is clogged. Check the positioning of the outlet hose and even out any kinks if necessary, or clean the drain pump and remove any foreign matter that might be present in the pump housing. Follow the manufacturer's instructions exactly when measuring out detergent. The wash water in the Too much detergent has main wash cycle is proprobably been used ducing too many suds. 37 Instructions for use Problem Possible cause The threaded fitting on the inlet hose is leaking. The drain pump cover is not closed properly. Water is running out from under the washing machine. [. . . ] Except in the event where liability is legally imposed, this declaration of guarantee terms excludes any compensation for damage outside the appliance for which the consumer wishes to assert his rights. In the event of legally admitted liability, compensation will not exceed the purchase price paid for the appliance. These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation instructions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and environmental conditions. [. . . ]