User manual AEG-ELECTROLUX LAV6080-WGB

[. . . ] This symbol guides you step by step in operating the unit. 2. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentally-responsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". [. . . ] Remove the washing detergent drawer with a firm pull. Remove the softener insert from the middle compartment. Clean the softener insert under running water. 5. Clean the compartments from the rear with warm water. Push on the softener insert as far as it will go so that it is secure. 29 Instructions for use 7. Use a brush to clean the entire rinsing-in part of the washing machine, especially the nozzles on the top side of the rinsing-in chamber. 8. Insert the washing detergent drawer into the guide rails and push it in. Washing Drum The washing drum is made of high-quality stainless steel. Rust deposits on the drum can occur due to foreign bodies in the washing which can cause rust. Do not clean the stainless steel drum with acidic antiliming agents, scouring agents containing chlorine or iron or steel wool. Our Customer Service Department has suitable agents available. Remove any rust deposits on the drum using a stainless steel cleaning agent. 0 Filling Door 0 Check regularly whether there are deposits or foreign bodies in the rubber sleeve behind the filling door and, if so, remove them. 30 Instructions for use What to do if . . . Remedying Faults In the event of a fault, try to solve the problem yourself with the aid of the information provided here. Close the cover properly. Stop the programme and Washing has been trapped in free the washing from the the door. Connect the emergency drain hose properly (see Section "Emergency Drain Procedure"). If the emergency drain hose is leaking, call Customer Service. Clean the detergent drawer, adjust the conditioner insert firmly. Pay attention to the maximum load quantity (see Programme Tables). In the case of easy-care fabrics, select the EASY IRON (STRIJKVRIJ/ FACILE A REPASSER) programme. The emergency drain hose is not connected properly or is leaking. Conditioner is not drawn in, the æ compartment for additives is full of water. The conditioner insert is not correctly set into the additive compartment or is clogged. Washing is heavily creased. Probably too much washing has been put in the drum. The washing has not been spun as dry as usual. The washing was not able to Always load the drum as ful be distributed evenly in the as possible with a combinadrum prior to spinning. tion of large and small items. 33 Instructions for use Problem Possible Cause There is a kink in the outlet hose. The maximum pump height (outlet height 1m from the washing machine's installation surface) has been exceeded. Contact Customer Service, who will be able to provide an adaptor kit for pump lifts greater than 1m as a special accessory. Switch off the machine and disconnect the mains plug. Wait until the wash programme has ended, the DOOR (DEUR/PORTE) light has gone off and the END (EINDE/FIN) light has come on. [. . . ] We give a twelve month guarantee for repairs, limited to the same defect. Except in the event where liability is legally imposed, this declaration of guarantee terms excludes any compensation for damage outside the appliance for which the consumer wishes to assert his rights. In the event of legally admitted liability, compensation will not exceed the purchase price paid for the appliance. These guarantee terms are only valid for appliances purchased and used in Belgium. [. . . ]