User manual AEG-ELECTROLUX LAV610

[. . . ] Switching on the appliance/selecting a programme . Changing spin speed/selecting rinse hold . Interrupting a programme/adding washing . Washing cycle complete/Removing the washing. [. . . ] Mix large and small items. Screw connection on the inTighten inlet hose. Water is leaking out un- Drain pump cover is not derneath the washing closed properly. At the Probably too much deterend of the washing cy- gent has been used. ENDdisplay flashes 2x, at the same time an acoustic signal sounds 2x. (Problems with water outflow) Maximum pumping height of 1m exceeded. Load washing carefully for the next wash. Close off emergency drain hose properly. Dose detergent exactly as instructed by manufacturer. Please contact Customer Care Department. Remove foreign bodies from pump housing. Clean out sink outlet. Drain pump is blocked. With connection to sink outlet: sink outlet is blocked. 20 Problem Fabric softener not rinsed in, w compartment for additives is filled with water. Possible cause Conditioner insert in the compartment for additives is not correctly attached or is blocked. Let the water cool before performing an emergency drain. Open the plinth flap and remove it. 2. Take out the emergency drain hose. 3. Place a shallow container underneath it. Then loosen the drain plug by turning it in an anti-clockwise direction and pull it out. If it is necessary to empty the container more than once, seal up the emergency drain hose with the drain plug while you are doing so. Push the drain plug firmly into the emergency drain hose and screw it tight in a clockwise direction. Place the emergency drain hose back in the support. 22 Drain pump The drain pump is maintenance-free. It is only necessary to open the pump cover if there is a malfunction and water is no longer being pumped out, e. Please make sure before loading the washing that there are no foreign bodies in the pockets or caught between the washing. [. . . ] Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: · a chemical or electrochemical reaction caused by water, · abnormal environmental conditions in general, · unsuitable operating conditions, · contact with harsh substances. [. . . ]