User manual AEG-ELECTROLUX LAV61300GB

[. . . ] ÖKO-LAVAMAT 61300 The environmentally friendly washing machine Instruction book Dear Customer, Please read this instruction book through carefully, before using the appliance. Please ensure you fully understand the safety instructions on the first pages of this instruction book!Retain the instruction book for future reference, and pass it on to any future owners. The warning triangle and/or the key words (Warning!, Caution!, Important!), emphasizes information which is important for your safety or the correct functioning of the appliance. [. . . ] Clean the entire compartment area of the washing machine with a brush. Set the detergent dispenser drawer into the guide tracks and push in. Washing Machine Drum The washing machine drum is made from rust-free stainless steel. Any objects left in the laundry which are likely to rust can stain the drum. Do not clean the stainless steel drum with descaling agents containing acids, scouring agents containing chlorine or iron or steel wool. AEG Service Force Centre has suitable agents available. Remove rust stains on the drum with a stainless steel cleaning agent. 0 Door 0 Regularly check if there are deposits or foreign bodies in the rubber seal behind the door and remove them. 26 Operating Instructions What to do when 3 The whistling noise when spinning may be different to your prevous washing machine which is due to the modern drive system. Trouble Shooting If you call out an engineer and the fault is listed here, a charge is levied even if the appliance is in guarantee. Fault Possible cause The mains plug is not connected. Washing machine does The fuse of the household not work. Switch on the appliance (pull out program selector). Close the door; you must hear a click as it locks. Unscrew the hose from the tap, remove the filter and clean it under flowing water. Adjust the feet according to the installation and connection instruction. The machine is not level. Washing machine vibrates during operation or is unstable. There is very little washing in This does not affect the the machine (e. g. Water could not be completely pumped out before the spin because there is a kink in the outlet hose or the drain pump is blocked. Check that the outlet hose is correctly laid and if applicable eliminate the kink or clean the drain pump and if necessary remove any foreign bodies from the pump housing. 27 Operating Instructions Fault Possible cause Remedy It may be necessary to reduce the amount of detergent used. Follow the detergent manufacturer´s recommendations. Check the inlet hose and if necessary replace it. Stop the program, remove the washing caught in the door, start a new program. Excessive foaming during the main wash. Probably too much washing powder was used. The inlet hose connection is not tight. Water is leaking out from under the washing machine. The inlet hose has a leak. Washing is caught in the door. Fabric softener is not added, compartment À for fabric softener is filled with water. Appliance does not spin, water in the drum. Suction cap in the fabric sof- Clean the detergent comtener compartment is not partment, fit the suction cap correctly fitted or is blocked. Pump out water and set the main wash cycle as desired. Switch off the machine and pull the plug out of the socket, clean the drain pump. Washing has not been Drain hose is too high. spun sufficiently, there is water left in the Drain pump is blocked. [. . . ] If a longer inlet hose is required contact your AEG Service Force Centre. Under no circumstances should hoses be connected together to provide a longer length. The rubber washers are either set into the inlet hose threaded connection or supplied separately in the installation kit. These washers must be fitted to ensure water tight seals. [. . . ]