User manual AEG-ELECTROLUX LAV623DB

[. . . ] This symbol guides you step by step in operating the unit. 2. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentally-responsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". [. . . ] Clean the compartments from the rear with warm water. Push on the softener insert as far as it will go so that it is secure. 29 Instructions for use 7. Use a brush to clean the entire rinsing-in part of the washing machine, especially the nozzles on the top side of the rinsing-in chamber. 8. Insert the washing detergent drawer into the guide rails and push it in. Washing Drum The washing drum is made of high-quality stainless steel. Rust deposits on the drum can occur due to foreign bodies in the washing which can cause rust. Do not clean the stainless steel drum with acidic antiliming agents, scouring agents containing chlorine or iron or steel wool. Our Customer Service Department has suitable agents available. Remove any rust deposits on the drum using a stainless steel cleaning agent. 0 Filling Door 0 Check regularly whether there are deposits or foreign bodies in the rubber sleeve behind the filling door and, if so, remove them. Cleaning the drain pump Paper clips, nails and so on can sometimes get into the washing machine with the washing and remain in the drain pump casing. Fluff and strands of fabric can gather on these items and block the drain pump. Therefore the drain pump should be cleaned at least once a year. 30 Instructions for use Warning!Switch off the washing machine and pull out the mains plug before cleaning the drain pump!The SPIN (CENTRIFUG. , ESSORAGE) indicator flashes. Unscrew the hose from the water supply tap, take out the filter and rinse it under the kitchen tap Check the supply tap, have it repaired if necessary. The filter in the water inlet hose coupling is clogged. The water supply tap is blocked with limescale, or is faulty. Remove locking devices as The locking devices were not described in the Installation removed. The adjustable feet are not set to the correct height. There are very few items of The washing machine is washing (for example, one noisy, or vibrates in use. The water could not be pumped out completely before spinning, as there is a kink in the outlet hose, or detergent solution pump is clogged. The detergent solution in the main wash foams excessively. Set the feet as described in the Installation and Connection instructions. Check the condition of the outlet hose, and straighten any kinks or folds, or clean the detergent solution pump, removing any foreign bodies from the pump casing if required. Follow precisely the manufacturer's instructions on the amount of detergent to use. 33 Instructions for use Fault Possible Cause Remedy The water inlet hose coupling Tighten the hose coupling. Check the outlet hose and replace if necessary. The detergent solution pump Close the cover properly. Stop the programme, remove the item from the door. [. . . ] Except in the event where liability is legally imposed, this declaration of guarantee terms excludes any compensation for damage outside the appliance for which the consumer wishes to assert his rights. In the event of legally admitted liability, compensation will not exceed the purchase price paid for the appliance. These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation instructions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and environmental conditions. [. . . ]