User manual AEG-ELECTROLUX LAV625SENSW

[. . . ] Important information concerning your safety and proper functioning of the appliance is highlighted with the warning triangle or the signal words (Warning!, Caution!, Attention!). This symbol guides you step by step when operating the appliance. . . . 1 3 2 Next to this symbol you receive additional information and practical tips on using the appliance. Tips and information about the economical and environmentally friendly use of the machine are marked with the clover. [. . . ] A rattling sound on startup in particular when using for the first time is caused by the circulation pump and is due to the design. Trouble Shooting In the event of a malfunction, try to eliminate the problem yourself with the help of the instructions listed here. If you request customer service assistance for one of the malfunctions listed here, or for an operator error, a charge will be billed for the customer service technician's visit, even during the guarantee period. If error code (1, (2 or (d appears at the multi-display, you may be able to eliminate the error yourself (see the following table of malfunctions). After the error has been eliminated, press the O/s (START/PAUSE) button. If the error code is again displayed, contact customer service. Please contact customer service for all other error displays and inform them of the error code. Malfunction Possible Cause Remedy Mains plug is not plugged in. Washing machine does Door is not closed properly. Close door; lock must engage audibly. Press O/s (START/PAUSE) O/s (START/PAUSE) button button until the program not pressed for long enough. Sieve in the threaded fitting on the water inlet hose is blocked. Unscrew the hose from the tap, remove the sieve and clean under running water 28 Operating instructions Malfunction Error code (d appears Possible Cause Door is probably not closed properly. The height adjustable threaded feet are not correctly adjusted. are building up in the at the tap is blocked. Sieve on threaded fitting for the water inlet hose on the Clean sieve. When an additional program button is pressed, the corresponding indicator does not illuminate. The cause is probably a No negative impact on the detergent with a high silicate rinsing results, possibly use content. The additional program selected cannot be combined Make another choice. with the program set. 30 Operating instructions If the washing results are not satisfactory If the washing is grey and there are calcium deposits in the drum Too little detergent was used. Program or temperature not set correctly. When using component detergents, the individual components were not used in the correct proportions. If there are still gray stains on the washing Washing soiled with ointments, grease or oils was washed with too little detergent. Too lower temperature was used for washing. A common cause is that softener particularly that in concentrated form has got onto the washing. [. . . ] Domaniewska 41 02-034 Warszawa tel. : 022 874 33 33 fax: 022 874 33 00 Russia Electrolux Russia Ltd. 16 Olympiysky prospekt 129090 Moscow Tel. : (095) 937 7837 Fax: (095) 926 5513 Latavia Electrolux Latavia Ltd. Terlaton Street 42/44 1011 Riga Tel. : 371 2 297821 Fax: 371 2 821286 Lthuania Electrolux Lthuania Verkui 29 2600 Vilnus Tel. : 372 272 3326 Fax: 372 272 3366 48 Service Departments/ Guarantee CondiIsrael Evis Ltd. Box 70 39 Tel-Aviv 67013 Tel. : 3257311 Malaysia Arzbergh Engineering No. [. . . ]