User manual AEG-ELECTROLUX LAV62600

[. . . ] ÖKO-LAVAMAT 62600 The environmentally friendly washing machine Instruction book Dear customer, Please read these user instructions carefully. Above all, observe the "Safety" section in the first pages. Keep these user instructions in a safe place for future reference. Please pass them along to future owners of the appliance. [. . . ] Appropriate cleansers are available from our customer service department. Remove rust deposits at the drum with a stainless steel cleanser. 0 Fill-in door 0 Check on a regular basis to see if deposits or foreign objects are present in or at the rubber sleeve behind the door, and remove. 27 Operating instructions What to do when. . . 3 The somewhat different, in comparison to older washing machines, whistling noise during spinning is due to the modern drive system. A rattling sound on startup ­ in particular when using for the first time ­ is caused by the circulation pump and is due to the design. Trouble Shooting In the case of a malfunction try to solve the problem with the aid of the notes given here. If you call in customer service to resolve one of the malfunctions listed here, or rectify an error made in the operation of the appliance, the customer service engineer's visit is not free of charge, even during the period of guarantee. Malfunction Washing machine does not work. Possible Cause Remedy Mains plug is not plugged in. Press ON/OFF button; Open tap; Reselect program; Press ON/OFF button again. Unscrew the hose from the tap, remove the sieve and clean under running water. The machine does not take in water. Tap is closed. Sieve in the threaded fitting on the water inlet hose is blocked. 28 Operating instructions Malfunction Possible Cause The height adjustable threaded feet are not correctly adjusted. Remedy Adjust threaded feet as per the installation instructions. Washing machine vibrates during operation or is unstable. There is only very little washing in the drum (e. g. Water cannot be completely pumped out because the drain hose is kinked or the circulation pump is blocked. Check the drain hose and, if necessary, remove any kinks, or clean the circulation pump and remove any foreign bodies from the pump housing as necessary. Dose detergent exactly in Excessive foaming dur- Probably too much detergent accordance with the manuing the main wash. Threaded fitting on the water inlet hose is leaking. Water runs out from under the washing machine. Circulation pump cover is not closed properly. Softener is not washed in, w compartment for conditioner is full with water. Appliance does not spin, water in the drum. Suction cap in the compartment for conditioner is not correctly positioned or is blocked. Check drain hose and if necessary replace. Stop program, remove washing from the door, start a new program. Clean detergent drawer, place suction cap firmly in position. Pump out the water and set the main wash as desired. 29 Operating instructions Malfunction Possible Cause Drain hose is kinked. Maximum pumping height (drain height 1m above the floor on which the machine is standing) exceeded. In the case of siphon connection: siphon is blocked. [. . . ] Box 70 39 Tel-Aviv ­ 67013 Tel. : 3257311 Malaysia Arzbergh Engineering No. 49A/B, Jalan Petaling Utama 7 4600 Petaling Jaya Tel. : 3 795 1084 Fax: 3 795 1082 Saudi Arabia Alia Trading Corporation P. O. Box 4101 King Abdul Aziz Street Riyadh Tel. : 4645977 Al Nahas Est. Box 1 15 29 Jeddah Tel. : 6606852 Slovenia Electrolux Slovenia D. O. O. [. . . ]