User manual AEG-ELECTROLUX LAV630

[. . . ] Useful tips and hints Environmental information 2 Contents Operating Instructions. Switching on the appliance/selecting a programme . Changing the spin speed/selecting rinse hold . Interrupting a programme/adding washing . [. . . ] Load carefully next time you wash. The emergency drain hose is Screw on the emergency leaking. At the end of the wash cycle the spinning stops. Probably too much detergent has been used. The maximum pump height The END indicator is of 1m has been exceeded. flashing twice, and simultaneously an acoustic signal is sounding The drain pipe is blocked. (Problems with the water outflow. ) Follow the manufacturer's instructions exactly when measuring out detergent. Please contact your local Service Force Centre Switch off the appliance. Remove foreign bodies from the pump housing. For sink spigot connections: Clean the spigot. The spigot is blocked. 20 Problem Conditioner has not been rinsed in, compartment w for conditioner is filled with water. Possible cause Remedy The softener insert in the Clean the detergent drawer, compartment for conditioninsert the conditioner insert ers has not been correctly firmly. Wait until the DOOR indicator is illuminated green. The programme will continue when the power cut has endThe door cannot be There has been a power cut. opened when the washing machine is switched (All the indicators have gone To remove the washing: out. ) on. Insert the plug firmly into the emergency drain hose and turn it in a clockwise direction until it is firmly in place. Replace the emergency drain hose into the retainer. Insert the plinth flap into place and close it. 22 Drain pump The drain pump is maintenance-free. It is only necessary to open the pump cover if there is a malfunction and water is no longer being pumped out, e. g. Before loading the machine, please always ensure that there are no foreign bodies present in the pockets or in between the items to be washed. which may find their way into the washing machine along with the washing will remain in the drain pump housing (foreign body trap that protects the pump wheel). 1 Warning!Before opening the cover of the drain pump, switch off the washing machine and remove the power plug from the power point. Place a cloth on the floor in front of the cover of the drain pump. Unscrew the pump cover in an anticlockwise direction and remove it. 4. Remove foreign bodies and fluff from the pump housing and from the pump wheel. 5. [. . . ] · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. · This guarantee is in addition to your statutory and other legal rights. [. . . ]