User manual AEG-ELECTROLUX LAV6650SENS.

[. . . ] Switching on the appliance/selecting a programme . Changing the spin speed/Selecting rinse hold . Interrupting a programme/Adding washing . End of the wash cycle/Removing the washing . [. . . ] Follow the manufacturer's instructions exactly when measuring out detergent. Please contact the Customer Care Department. Remove foreign bodies from the pump housing. Drain pump is blocked. For sink spigot connections: Clean the sink spigot. The sink spigot is blocked. 20 Problem Conditioner not rinsed in, w compartment for additives is filled with water. Possible cause Conditioner insert in the compartment for additives is not correctly attached or is blocked. Door locked. Remedy Clean the detergent drawer, insert the conditioner insert firmly. Wait until indicator (DOOR) is lit green. The programme will continue when the power cut is over. To remove washing: If water can be seen in the appliance, before opening the door, first drain off the water. (See section "Carrying out an emergency drain". ) Observe maximum loads. The door cannot be opened when the wash- There has been a power cut. ing machine is switched (All indicators are off. ) For safety reasons, the door on. 4 to 10 minutes. Washing is heavily creased. Possibly too much washing was loaded. 21 If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum · Too little detergent is being used. If it is necessary to empty the container more than once, seal up the emergency drain hose with the drain plug while you are doing so. Push the drain plug firmly into the emergency drain hose and screw it tight in a clockwise direction. Place the emergency drain hose back in the support. Insert the plinth flap and close it. 23 Drain pump The drain pump is maintenance-free. It is only necessary to open the pump cover if there is a malfunction and water is no longer being pumped out, e. Please make sure before loading the washing that there are no foreign bodies in the pockets or caught between the washing. that may have got into the washing machine with the washing remain in the pump housing (foreign body trap that protects the pump wheel). 1 Warning!Before opening the pump cover, switch off the washing machine and remove the mains plug from the socket. Place a cloth on the floor in front of the drain pump cover. Unscrew the pump cover in an anticlockwise direction and remove it. 4. Remove foreign bodies and fluff from the pump housing and from the pump wheel. 5. [. . . ] 10 Rothwell Avenue Albany - Auckland 4399 Auckland 1 New Zealand Tel. : 00 64-92 59 11 11 Fax: 00 64-92 59 11 12 Syria WATTAR CO. Box 36109 Mazzeh - Damascus Direct Phone: 00963116132649 Fax: 00963116119537 Iran ARIAN International Development Co. AEG Showroom Shariati, Balatar as Safar Teheran / Iran Phone No. Service: 021 / 312 27 67 / 8 Poland Electrolux Poland Sp. [. . . ]