User manual AEG-ELECTROLUX LAV6950

[. . . ] This symbol guides you step by step through the operation of the appliance. . . . 3 2 This symbol gives you additional information and practical tips on using the appliance. Tips and information about the economical and environmentally friendly use of the machine are marked with the clover leaf. In the event of a malfunction, these operating instructions contain information on how to remedy these faults yourself. [. . . ] Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee. · If the fault code C1 or C2 is shown in the multi-display, you may be able to remedy the fault yourself (see the Fault table below). After clearing the fault, press the START/PAUSE button. If the fault code is shown again, contact your local Service Force Centre. · For all other faults displayed in the multi-display, please contact your local AEG Service Force Centre, stating the fault code. Problem Possible Cause The mains plug is not plugged in. START/PAUSE button not pressed long enough. Close the door; The lock must engage audibly. Keep the START/PAUSE button pressed until the programme begins. Cancel the child safety feaThe child safety feature is set ture (see Section "Child Safety Feature"). Open the water tap. Water is not running. Error code (1 appears. Close the water tap. Unscrew Filter in screw connection of the hose from the tap, remove the filter and clean unthe inlet hose is blocked. The conditioner insert in the compartment for the conditioner is not correctly attached or is blocked. Washing heavily creased Probably too much washing put in the drum. Drain hose is kinked. The washing is not suf- Maximum pump head (disficiently spun. Water is charge height 1m from the unit's floor) is exceeded. Drain pump blocked. The door cannot be opened when the appliance is switched on. The door is locked for safety Wait until the DOOR/LIGHT reasons (DOOR/LIGHT display display lights up green. The programme protection function is set. Cancel programme protection (see the section "Programme protection"). Open the water tap fully. Remnants of detergent Close the water tap. Unscrew are building up in the The inlet hose filter in the the inlet hose from the water coupling of the inlet hose at detergent drawer. tap and the appliance and the tap is blocked. The cause is probably a detergent with a high silicate content. No negative influence on the rinsing results, use a liquid detergent if necessary. 33 Operating Instructions Problem Possible Cause Remedy When pressing a proThe selected programme opgramme option button tion cannot be combined Make another selection. [. . . ] The purchaser´s statutory rights are not affected by this guarantee. European Guarantee If you should move to another country within Europe then your guarantee moves with you to your new home subject to the following qualifications: ­ The guarantee starts from the date you first purchased your product. ­ The guarantee is for the same period and to the same extent for labour and parts as exist in the new country of use for this brand or range of products. ­ This guarantee relates to you and connot be transferred to another user. [. . . ]