User manual AEG-ELECTROLUX LAV6955

[. . . ] Useful tips and hints Environmental information 2 Contents Operating Instructions. Switching on the appliance for the first time - setting the language. Carrying out a wash programme prior to first use. Switching on the appliance/selecting a program. [. . . ] OPTIONS OK TIME RPM display changes to the next special function. Press the OPTIONS key repeatedly, until your program set appears again. Language 1. Turn the program knob to any program and press the OPTIONS key repeatedly until the SETUP symbol flashes. Press the OPTIONS key repeatedly, until the display shows LANGUAGE. Press the OPTIONS key reSprache peatedly, until the desired language appears in the dis- DEUTSCH aaaaaBaaaa play, e. OPTIONS OK TIME RPM changes to the next special function. Press the OPTIONS key repeatedly, until your program set appears again. 24 Clock 1. Turn the program knob to any program and press the OPTIONS key repeatedly until the SETUP symbol flashes. Press the OPTIONS key repeatedly until CLOCK is shown in the display. Using the OPTIONS key set 11. 17 Clock the desired time. With each Set time press of the key, the display aaaaaBaaaa moves on by one minute. Do not clean the drum with acidic descaling agents, scouring agents containing chlorine or iron or steel wool. Remove any rust deposits on the drum with a cleaning agent for stainless steel. Run a washing cycle without any washing to clean off any cleaning agent residues. Program: LINEN/EASY CARES 60, option Time saving: VERY SHORT, add approx. 1/4 of a measuring cup of washing powder. 28 Door and rubber collar Regularly check whether deposits or foreign bodies are present in the folds of the rubber collar or on the inside of the glass door. Clean the glass in the door and the rubber collar regularly. What to do if. . . Remedying small malfunctions If while the appliance is operating a short acoustic signal sounds 3 times and one of the following messages appears in the display: "No incoming water/Check tap & Hose", "No drain - check/drain hose/filter" or "Pump Blocked", "Door not Closed", please have a look at the following table. When the fault is remedied, press the START/PAUSE key. If "Warning : E and number or letter" is displayed: Switch the appliance off and on again. If the warning is displayed again, please contact the Service Force Centre and inform them of the warning. Problem Possible cause Mains plug not plugged in or fuse not working. Check fuse. Close door - there should be Washing machine does not Door not closed properly. [. . . ] Push the drain hose onto the spigot and secure with a clip if required. Ensure the drain hose is looped upwards to prevent waste water from the sink entering the washing machine. The end of the drainage hose must not be submerged in the pumped-out water. Otherwise, the water could be sucked back into the appliance. [. . . ]