User manual AEG-ELECTROLUX LAV72620W

[. . . ] ÖKO-LAVAMAT 72620 update The environmentally friendly washing machine Instruction book Dear Customer, Please read this instruction book through carefully, before using the appliance. Please ensure you fully understand the safety instructions on the first pages of this instruction book!Retain the instruction book for future reference, and pass it on to any future owners. The warning triangle and/or the key words (Warning!, Caution!, Important!), emphasizes information which is important for your safety or the correct functioning of the appliance. [. . . ] Unscrew the hose from the tap, remove the filter and clean under running water. Press the door firmly in the area of the lock. Error code (d appears 28 Operating Instructions Malfunction Possible Cause The machine is not level. Remedy Adjust the feet according to the installation and connection instruction. Washing machine vibrates during operation or is unstable. There is only very little washing in the machine (e. g. Water could not be completely pumped out prior to spinning because the drain hose is kinked or the drain pump is blocked. Check the drain hose and if necessary remove any kink or clean the drain pump and remove any foreign bodies from the pump housing. It may be necessary to reduce the amount of deterExcessive foaming dur- Probably too much detergent gent used. Follow the detering the main wash was used. gent manufacturer's recommendations. Threaded fitting on the water inlet hose is leaking. Water runs out from under the washing machine. Fabric softener is not added, compartment À for fabric softener is filled with water. Check the inlet hose and if necessary replace it. Stop the program, remove the washing caught in the door, start a new program. Suction cap in the fabric sof- Clean detergent dispenser tener compartment is not drawer, place suction cap correctly fitted or is blocked. Too much washing was placed in the appliance. Put less washing in the appliance. 29 Operating Instructions Malfunction Possible Cause Drain hose is kinked. Washing has not been spun sufficiently, there is water left in the Drain pump is blocked. Switch off the machine and pull the plug out of the socket. Carry out emergency emptying (see "Carrying out an Emergency Emptying"). Clean the drain pump. The water drainage system is Clean the blockage. Door cannot be opened The door is locked due to when the machine is safety reasons (DOOR switched off. Open the water tap fully. The inlet hose filter in the Remnants of detergent coupling of the inlet hose at Clean filter. are building up in the the tap is blocked. The inlet valve filter in the coupling of the inlet hose at Clean filter. [. . . ] i. ): Unscrew the inlet hose from the appliance at the inlet solenoid valve and remove the flow regulator (to do this, remove the sieve with needle-nose pliers and remove rubber washer behind the sieve). Retain the washer for future use. 47 Installation and Connection Instructions Inlet Hose Connection Important!This appliance must be connected to the cold water supply only. The inlet hose provided is 1. 2 or 1. 3 metres depending on the model. [. . . ]