User manual AEG-ELECTROLUX LAV73620-W

[. . . ] ÖKO-LAVAMAT 74620 update The environmentally friendly washing machine Instruction book Dear customer, Please read these user instructions carefully. Above all, observe the "Safety" section in the first pages. Keep these user instructions in a safe place for future reference. Please pass them along to future owners of the appliance. [. . . ] If the error code is again displayed, contact customer service. · Please contact customer service for all other error displays and inform them of the error code. Malfunction Possible Cause Remedy Mains plug is not plugged in. Washing machine does Door is not closed properly. START/PAUSE button not pressed for long enough. Sieve in the threaded fitting on the water inlet hose is blocked. Press START/PAUSE button until the program starts. Unscrew the hose from the tap, remove the sieve and clean under running water Close the door again. Press the door firmly in the area of the lock. 28 Operating instructions Malfunction Possible Cause The height adjustable threaded feet are not correctly adjusted. Remedy Adjust the feet as per the installation and connection instructions. Washing machine vibrates during operation or is unstable. There is only very little washing in the drum (e. g. Water could not be completely pumped out prior to spinning because the drain hose is kinked or the circulation pump is clogged. Check the drain hose and if necessary remove any kink or clean the circulation pump and remove any foreign bodies from the pump housing. Dose detergent exactly in Excessive foaming dur- Probably too much detergent accordance with the manuing the main wash was used. Threaded fitting on the water inlet hose is leaking. Water runs out from under the washing machine. Circulation pump cover is not closed properly. Softener is not washed in, the À compartment for conditioner is full with water. Suction cap in the compartment for conditioner is not correctly positioned or is blocked. Too much washing was placed in the appliance. Check drain hose and if necessary replace. Stop the program, remove washing from the door, start a new program. Clean detergent drawer, place suction cap firmly in position. Put less washing in the appliance. 29 Operating instructions Malfunction Possible Cause Drain hose is kinked. Maximum pumping height (drain height 1m above the floor on which the machine is standing) exceeded. [. . . ] This guarantee does not apply to light bulbs, loose glass, glass oven doors and enamelled surfaces or to dust bags, filters and other parts subject to wear and tear. AEG shall not be responsible in terms of this guarantee for the replacement or repair of any part of the equipment which may have been damaged in transit. Repairs carried out under guarantee do not extend the guarantee period for the appliance. Parts removed during guarantee repairs become the property of AEG. [. . . ]