User manual AEG-ELECTROLUX LAV7400

[. . . ] LAVAMAT 7400 ELECTRONIC Washing Machine User Information Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. 1 Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). [. . . ] If the fault code is displayed again, please contact the Customer Service department quoting the fault code. Problem Possible cause The power plug is not connected. Washing machine does The door is not closed properly. The START/PAUSE (START/ PAUZE/MARCHE/PAUSE) button was not pressed for long enough. Remedy Connect the plug to a power outlet. Close the door - there should be an audible click. Press and hold the START/ PAUSE (START/PAUZE/ MARCHE/PAUSE) button until the programme starts. Disengage the child safety device (see section "Child safety device"). Restart the programme. Fault code E40 apThe door is not closed proppears. light flashes 4 times. 29 Instructions for use Problem Possible cause The tap is turned off. The filter in the threaded inFault code E10 aplet hose fitting is clogged. Tap is furred with lime scale or faulty. The transportation lock has not been removed. Unscrew the hose from the tap, take out the filter and clean it under running water. Check the tap and have it repaired, if necessary. Remove the transportion lock as described in the installation and connection instructions. Adjust the feet as described in the installation and connection instructions. The height-adjustable feet have not been set correctly. The washing machine vibrates when operating or is not stable. There is very little washing in Operation is not affected by the drum (e. g. Water could not be drained completely before spinning, because the outlet hose has a kink in it or the drain pump is clogged. Check the positioning of the outlet hose and eliminate any kinks if necessary or clean the drain pump and remove any foreign matter that may be located in the drain pump housing. 30 Instructions for use Problem Possible cause The threaded inlet hose fitting is leaking. The drain pump cover is not closed properly. Water is running out from under the washing machine. Check the outlet hose and replace if necessary. [. . . ] For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation instructions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and environmental conditions. For appliances purchased abroad, the user must first ensure that they meet the qualifications required in Belgium. Non-essential or requested adjustments are not covered by the guarantee and are not possible in all cases. Our consumer services department is always at your disposal, even after the guarantee period has expired. [. . . ]