User manual AEG-ELECTROLUX LAV7407

[. . . ] LAVAMAT 7400 ELECTRONIC Washing Machine User Information Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. 1 Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). [. . . ] If you call Customer Service to deal with one of the faults listed here or to remedy an operating fault, the customer service technician's visit will not be free of charge, even during the warranty period. · If the fault code E10, E20 or E40 is shown in the multidisplay, you may be able to remedy the fault yourself (see Faults Table below). After remedying the fault, press the button START/PAUSE (START/ PAUZE, MARCHE/PAUSE). If the fault code is shown again, inform Customer Service. · In the case of all other displayed faults (E and number or letter), please inform the Customer Service and state the fault code. Fault Possible Cause Remedy The plug is not in the socket. The fuse or protection device Replace/reset the fuse. The machine door was not closed properly. The START/PAUSE (START/ PAUZE, MARCHE/PAUSE) button was not pressed long enough. Press the START/PAUSE (START/PAUZE, MARCHE/ PAUSE) until the Programme begins. Release the child safety device (see "Childsafety device"). Start the programme again. Error code E40 appears. The MAIN WASH The door is not closed (HOOFDWAS, LAVAGE) properly. indicator flashes. 31 Instructions for use Fault Possible Cause The water supply tap is closed. The SPIN (CENTRIFUG. , ESSORAGE) indicator flashes. Unscrew the hose from the water supply tap, take out the filter and rinse it under the kitchen tap Check the supply tap, have it repaired if necessary. The filter in the water inlet hose coupling is clogged. The water supply tap is blocked with limescale, or is faulty. Remove locking devices as The locking devices were not described in the Installation removed. The adjustable feet are not set to the correct height. There are very few items of The washing machine is washing (for example, one noisy, or vibrates in use. The water could not be pumped out completely before spinning, as there is a kink in the outlet hose, or detergent solution pump is clogged. The detergent solution in the main wash foams excessively. Set the feet as described in the Installation and Connection instructions. Check the condition of the outlet hose, and straighten any kinks or folds, or clean the detergent solution pump, removing any foreign bodies from the pump casing if required. Follow precisely the manufacturer's instructions on the amount of detergent to use. 32 Instructions for use Fault Possible Cause Remedy The water inlet hose coupling Tighten the hose coupling. [. . . ] Non-essential or requested adjustments are not covered by the guarantee and are not possible in all cases. Our consumer services department is always at your disposal, even after the guarantee period has expired. Address for our consumer services department: ELECTROLUX HOME PRODUCTS BELGIUM Bergensesteenweg, 719 - 1502 LEMBEEK Tel. : 02. 363. 04. 44 50 Customer services Customer services Belgium Tel. : Electrolux Home Products Belgium ELECTROLUX SERVICE Bergensesteenweg 719 1502 Lembeek Province de Liège: S. D. E. Rue Gaucet 26 4020 Liege Fax. : Consumer services 02/363. 04. 44 02/363. 04. 00 02/363. 04. 60 04/343. 11. 60 04/343. 47. 68 51 52 53 Index Index C Care agent . [. . . ]