User manual AEG-ELECTROLUX LAV74650

[. . . ] ÖKO-LAVAMAT 74650 update The Environmentally-Friendly Washing Machine User Information Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. 1 Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). [. . . ] Use a brush to clean the entire rinsing-in part of the washing machine, especially the nozzles on the top side of the rinsing-in chamber. 8. Insert the washing detergent drawer into the guide rails and push it in. Washing Drum The washing drum is made of high-quality stainless steel. Rust deposits on the drum can occur due to foreign bodies in the washing which can cause rust. Do not clean the stainless steel drum with acidic antiliming agents, scouring agents containing chlorine or iron or steel wool. Our Customer Service Department has suitable agents available. Remove any rust deposits on the drum using a stainless steel cleaning agent. 0 Filling Door 0 Check regularly whether there are deposits or foreign bodies in the rubber sleeve behind the filling door and, if so, remove them. 33 Instructions for use What to do if . . . Remedying Faults In the event of a fault, try to solve the problem yourself with the aid of the information provided here. If you call Customer Service to deal with one of the faults listed here or to remedy an operating fault, the customer service technician's visit will not be free of charge, even during the warranty period. · If the fault code E10, E20 or E40 is shown in the multidisplay, you may be able to remedy the fault yourself (see Faults Table below). When you have remedied the fault, press the START/PAUSE (START/ PAUZE, MARCHE/PAUSE) button. · With all other displayed faults (E plus number or letter): switch appliance off and on again. Reset the wash programme and press the START/PAUSE button. If the fault code is displayed again, please contact the Customer Service department quoting the fault code. Problem Possible Cause The mains plug is not plugged in. The fuse of the building's wiring is not in order. The filling door is not correctly closed. The button START/PAUSE (START/ PAUZE, MARCHE/ PAUSE) was not pressed for long enough. The filling door cannot The child lock is set. The indicator MAIN WASH (HOOFDWAS, LAVAGE) flashes. The filling door is not correctly closed. Close the filling door; the lock must engage audibly. Press the button START/ PAUSE (START/ PAUZE, MARCHE/PAUSE) until the program begins. Cancel the child lock (see section , , Child Lock"). Restart the program. 34 Instructions for use Problem Possible Cause Water valve is closed. [. . . ] For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation instructions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and environmental conditions. For appliances purchased abroad, the user must first ensure that they meet the qualifications required in Belgium. Non-essential or requested adjustments are not covered by the guarantee and are not possible in all cases. Our consumer services department is always at your disposal, even after the guarantee period has expired. [. . . ]