User manual AEG-ELECTROLUX LAV76769

[. . . ] ÖKO-LAVAMAT 76760 update The Environmentally-Friendly Washing Machine User Information Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. 1 Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). [. . . ] If you call Customer Service to deal with one of the faults listed here or to remedy an operating fault, the customer service technician's visit will not be free of charge, even during the warranty period. · If the fault code C1, C2 or Cd is shown in the multidisplay, you may be able to remedy the fault yourself (see Faults Table below). After remedying the fault, press the button START/PAUSE (START/PAUZE, MARCHE/PAUSE). If the fault code is shown again, inform Customer Service. · In the case of all other displayed faults (C and number or letter), please inform the Customer Service and state the fault code. Problem Possible cause The power plug is not connected. The washing machine is The door is not closed properly. The START/PAUSE (START/ PAUZE, MARCHE/PAUSE) button has not been pressed long enough. Remedy Connect the plug to a power outlet. Close the door; the catch must audibly latch. Press the START/PAUSE (START/PAUZE, MARCHE/ PAUSE) button until the programme begins. Disengage the child safety device (see section "Child safety device"). The Cd error code has appeared in the multidisplay. The PRE WASH The door is not closed prop(VOORWAS, PRELAVAGE), RINSE (SPOELEN, erly. RINCAGE) and RINSE+ (SPOELEN+, RINCAGE+) indicators are flashing. Close the door properly. Restart the programme. 36 Instructions for use Problem Possible cause The stopcock is closed. The filter in the threaded inThe (1 error code has let hose fitting is clogged. Stopcock is furred with limescale or faulty. The transport locks have not been removed. Unscrew the hose from the stopcock, remove the filter and wash it under running water. Check the stopcock and have it repaired if necessary. Remove the transport locks as described in the Installation and Connection instructions. Adjust the feet as described in the Installation and Connection instructions. The height-adjustable feet have not been set correctly. The washing machine vibrates when operating or is not still. There is not very much washThe operation of the appliing in the drum (e. g. [. . . ] For appliances purchased abroad, the user must first ensure that they meet the qualifications required in Belgium. Non-essential or requested adjustments are not covered by the guarantee and are not possible in all cases. Our consumer services department is always at your disposal, even after the guarantee period has expired. Address for our consumer services department: ELECTROLUX HOME PRODUCTS BELGIUM Bergensesteenweg, 719 - 1502 LEMBEEK Tel. : 02. 363. 04. 44 58 Customer services Customer services Belgium Tel. : Electrolux Home Products Belgium ELECTROLUX SERVICE Bergensesteenweg 719 1502 Lembeek Province de Liège: S. D. E. [. . . ]