User manual AEG-ELECTROLUX LAV84730-W

[. . . ] ÖKO-LAVAMAT 84730 update The Environmentally-Friendly Washing Machine User Information Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. 1 Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). [. . . ] Remove any rust deposits on the drum using a stainless steel cleaning agent. 0 Filling Door 0 Check regularly whether there are deposits or foreign bodies in the rubber sleeve behind the filling door and, if so, remove them. 30 Instructions for use Cleaning the drain pump Paper clips, nails and so on can sometimes get into the washing machine with the washing and remain in the drain pump casing. Fluff and strands of fabric can gather on these items and block the drain pump. Therefore the drain pump should be cleaned at least once a year. Switch off the washing machine and pull out the mains plug before cleaning the drain pump!First carry out an emergency emptying (see section "Carry Out Emergency Emptying"). Place a towel on the floor in front of the cover of the solution pump. Unscrew the drain pump cover anticlockwise and pull it out. 1 4. Remove any foregin bodies from the pump housing. 5. Insert the webs on the cover laterally into the guide slots and screw the cover firmly into place clockwise. 6. Close the emergency emptying hose and place it in the holder. Close the flap. 31 Instructions for use What to do if . . . Remedying Faults In the event of a fault, try to solve the problem yourself with the aid of the information provided here. If you call Customer Service to deal with one of the faults listed here or to remedy an operating fault, the customer service technician's visit will not be free of charge, even during the warranty period. · It the fault code C1 or C2 appears in the multi-display, you may be able to remedy the fault yourself (see the fault table below). After remedying the fault, press the button START/PAUSE (START/PAUZE, MARCHE/PAUSE). If the fault code is displayed again, please inform the Customer Service. · In the case of all other displayed faults (C and number or letter), please inform the Customer Service and state the fault code. Problem Possible Cause The mains plug is not plugged in. The fuse of the building's wiring is not in order. The filling door is not correctly closed. The button START/PAUSE (START/PAUZE, MARCHE/ PAUSE) was not pressed for long enough. The filling door cannot The child lock is set. Close the filling door; The lock must engage audibly. Press the button START/ PAUSE (START/ PAUZE, MARCHE/PAUSE) until the program begins. [. . . ] ­ It is not permitted to submerge the end of the drainage hose into the pumped-off water. ­ When hooked into a wash-basin or a bath tub the drainage hose must be protected from slipping out of place by the supplied slip-on elbow. Otherwise the repelling power of the draining water can press the hose out of the sink. Fix the elbow to the water tap or to the wall with string. 0 51 Setting up and connection instructions Delivery Heads over 1m To pump off the washing / rinsing agent, every washing machine has a pump which transports liquids via the drainage hose up to a height of 1m, calculated from the machine's floor. [. . . ]