User manual AEG-ELECTROLUX LAV84741

[. . . ] ÖKO-LAVAMAT 84760 update The Environmentally-Friendly Washing Machine User Information Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. 1 Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). [. . . ] Move the path of the hose and, if necessary, remove kink or clean water pump and, if necessary, remove foreign body from pump housing. Dose washing agent exactly according to manufacturers instructions. 36 Instructions for use Problem Possible cause Connection to the inflow hose is leaking. Cover of the water pump is not properly closed. Check drainage hose and, if necessary, replace. Abort programme, remove washing from door. Close off emergency emptying hose (see section , , Carry out energy emptying operation"). In the case of a leaking emergency emptying hose, call the customer service. Emergency emptying hose is not properly closed off or is leaking. The emptying pump runs continuously also when the appliance is switched off. Conditioner has not rinsed, compartment æ for care agent is filled with water. Close water tap, remove Anti-flood system Aqua Conelectric plug and inform trol has displayed. Conditioner insert in the compartment for care agent is not properly placed on or is blocked. Clean detergent drawer, seat conditioner insert properly. Note maximum filling quantity (see programme tables). For easy-care textiles select the EASY IRON (STRIJKVRIJ, SANS REPASSAGE) programme. Washing is badly creased. Probably too much washing has been put in. The washing has not been spun as dry as usual. The washing was not able to Always load the drum as ful be distributed evenly in the as possible with a combinadrum prior to spinning. tion of large and small items. 37 Instructions for use Problem Possible cause Remedy There is a kink n the drainage Remove kink. Maximum pump height (emptying height 1m from Washing is not spun. base surface of the appliRemaining water is vis- ance) is exceeded. For pumping heights over 1m, they have a supplementary set as special spares available. Switch off appliance and pull out electric plug. Clean water pump. At the siphon connection: SiClean siphon. Door is locked for safety rea- Wait till display DOOR/LIGHT sons (display DOOR/LIGHT is (DEUR/LICHT, PORTE/ECLAIR. ) Door cannot be opened Off). when appliance is Cancel programme security switched on. Programme security is (see section , , Programme seswitched On. Detergent remains form inthe washing powder/liquid drawer. Open water tap fully. Close water tap. [. . . ] These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation instructions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and environmental conditions. For appliances purchased abroad, the user must first ensure that they meet the qualifications required in Belgium. Non-essential or requested adjustments are not covered by the guarantee and are not possible in all cases. [. . . ]