User manual AEG-ELECTROLUX LAV86820-W

[. . . ] KO-LAVAMAT 86820 update The environmentally friendly washing machine User Instructions Dear customer, Please read these user instructions carefully. Above all, observe the "Safety" section in the first pages. Keep these user instructions in a safe place for future reference. Please pass them along to future owners of the appliance. [. . . ] Sieve in the threaded fitting on the water inlet hose is blocked. Unscrew the hose from the tap, remove the sieve and clean under running water. 30 Operating instructions Malfunction Error message (d appears Possible Cause Door is probably not closed properly. The height adjustable threaded feet are not correctly adjusted. Press the door firmly in the area of the lock. Adjust the feet as per the installation and connection instructions. Washing machine vibrates during operation or is unstable. There is only very little washing in the drum (e. g. Water could not be completely pumped out prior to spinning because the drain hose is kinked or the circulation pump is clogged. Check the drain hose and if necessary remove any kink or clean the circulation pump and remove any foreign bodies from the pump housing. Dose detergent exactly in Excessive foaming dur- Probably too much detergent accordance with the manuing the main wash. Threaded fitting on the water inlet hose is leaking. Water runs out from under the washing machine. Circulation pump cover is not closed properly. Softener is not washed in, compartment w for conditioner is full with water. Suction cap in the compartment for conditioner is not correctly positioned or is blocked. Check drain hose and if necessary replace. Stop program, remove washing from the door, start a new program. Clean detergent drawer, place suction cap firmly in position. 31 Operating instructions Malfunction Possible Cause Drain hose is kinked. Maximum pumping height (drain height 1m above the floor on which the machine is standing) exceeded. In the case of siphon connection: siphon is blocked. Please contact customer service who have a retrofit kit for pumping to heights of greater than 1m. Switch off the machine and unplug from the mains, clean the circulation pump. Clean siphon. Washing is not spun properly, water is still visible in the drum. Fault code (2 appears. The fill-in door cannot be opened when the appliance is switched on. The door is locked for safety Wait until K/W is illumireasons (display K/W is not nated in green. Program protection is deactivated (see "Program Protection"). [. . . ] Box 1 15 29 Jeddah Tel. : 6606852 Slovenia Electrolux Slovenia D. O. O. 132 1000 Ljubljana Tel. : 61 1234 137 Fax: 61 1234 238 Singapore Japan Arzbergh Engineering Electrolux Japan Ltd. Yasuda Warehouse 4F 3-3-12 19 Tanglin Road 06-07 Singapore 247909 Heiwajima Ota-Ku Tel. : 65 7356572 Tokyo Fax: 7351124 Tel. : 81 3 3544 3363 Fax: 81 3 3763 6143 Thailand OLYMPIA Thai Ltd. 44 Ratchadapisek Road 10320 Bangkok Tel. : 2 513 6111 Fax: 2 513 2574 Hungary Electrolux Lehel KFT (AEG Div) Erzsebet'Kiralyne Utja 87 1142 Budapest Tel. : 00361/251 84 44 Slovakia Rep. [. . . ]