User manual AEG-ELECTROLUX LAV88830-W

[. . . ] ÖKO-LAVAMAT 88830 update The environmentally friendly washing machine User information Dear Customer, Please read this user information carefully. Pay particular attention to the section "Safety" on the first Info pages. Please keep this user information in a safe place for later reference. Pass it on to any future owners of the unit. 1 The warning triangle and /or signal words (Warning!, Caution!, Important!) emphasise information which is important for your safety or for the unit's functional reliability. [. . . ] tion or it is on an une- dressing gown). Check the laying of the The water could not be com- drainage hose and eliminate the bend if necessary, or pletely pumped off before clean the solution pump and, spinning because the drainage hose is bent or if required, remove foreign the solution pump is blocked. The washing solution of the main wash froths up a lot. Too much detergent was probably used Meter the detergent exactly in accordance with the manufacturer's information. 32 Operating Instructions Problem Possible Cause Remedy The screw connection on the Tighten the intake hose intake hose is leaky. The washing solution pump cover is not correctly closed. Water is flowing out from beneath the washing machine. Check the drainage hose and replace it if necessary. Close cover correctly. Abort the program and reWashing in caught in the fill- move the washing through ing door. Close the emergency emptying hose correctly (see the section "Carry out emergency emptying"). Inform Customer Service if the emergency emptying hose leaks. Turn off the tap, then remove the plug from the mains and inform Customer Service. The emergency emptying hose is not correctly closed or leaks. The drain pump for the washing machine runs The Aqua Control anti-flood constantly - even when system has been activated. Conditioner was not washed in, compartment æ for care agents is filled with water. Conditioner insert in the Clean the detergent drawer, compartment is not correctly attach the conditioner insert attached or is blocked. Pay attention to the maximum filling quantity (see Program tables). In the case of easy-care textiles, select the program EASY IRON. Washing heavily creased Too mush washing probably put in. The washing has not been spun as dry as usual. The washing was not able to Always load the drum as ful be distributed evenly in the as possible with a combinadrum prior to spinning. tion of large and small items. 33 Operating Instructions Problem Possible Cause Drainage hose bent. Remedy Remove the bend. Washing is not well spun. Residual water is still visible in the drum. Fault code (2 appears. Contact your customer servMaximum pump head (drain- ice. For pumping heights age height 1m from the floor over lm he can offer you a under the unit) is exceeded. If a siphon is connected: Siphon blocked. Door locked for safety reasons (display DOOR/LIGHT not illuminated from behind). Switch off the unit and pull out the mains plug. [. . . ] 1142 Budapest Tel. : 00361/467-3200 Singapore Arzbergh Engineering 19 Tanglin Road 06-07 Singapore 247909 Tel. : 65 7356572 Fax: 7351124 Slovakia Rep. Seberiniho 1 821 03 Bratislava Tel. : 02 4333 4322, 4355 Fax: 02 4333 6976 USA ANDI Co. East 65 Campus Plaza Edison, New Jersey 0837 USA/Tel. : (201) 2258839 South Africa AEG (Pty) Ltd. Box 1 02 64 Kew/Johannesburg 2000 Tel. : 8069111 Syria Masri & Shami P. O. [. . . ]