User manual AEG-ELECTROLUX LAV88840-W

[. . . ] ÖKO-LAVAMAT 88840 update The environmentally friendly washing machine User information Dear Customer, Please read this instruction book carefully before using the appliance. Please ensure you fully understand the safety instructions on the first pages of this instruction book. Retain the instruction book for future reference, and pass it on to any future owners. 1 The warning triangle and / or key words (Warning!, Caution!, Important!) give information that is important for your safety or the function of the appliance is highlighted. It is imperative that this information is observed. 0 1. [. . . ] Open the water tap. Close the water tap. DisconThe filter in the socket of the nect the hose from the water Water is not entering. inlet hose connection is tap, remove the filter and Fault code (1 appears. Water tap is blocked with limescale or is faulty. Check the water tap and have it repaired if necessary. 33 Operating Instructions Problem Possible Cause Remedy Remove the transit packagThe transit packaging has not ing as described in the Installation and Connection been removed. The washing machine vibrates when operating or is noisy. Adjust the feet according to the Installation and Connection instructions. There is very little washing in This does not affect the opthe drum (for example, one eration of the machine. Water could not be fully drained out before spinning, because the drain hose is kinked or the water pump is blocked. Check the drain hose and remove any kink if necessary or clean the water pump and if necessary remove foreign bodies from the pump housing. It may be necessary to reduce the amount of deterExcessive foaming dur- Probably too much detergent gent used. The screw connection on the Tighten the inlet hose screw inlet hose is leaking. The drain pump cover is not correctly closed. Check the drainage hose and replace if necessary. Stop the programme and remove the washing caught in the door. Close the emergency emptying hose (see Section "Carry out emergency emptying"). Call your local Service Force Centre, if the emergency emptying hose is leaking. The emergency emptying hose is not correctly closed or is leaking. 34 Operating Instructions Problem The drain pump runs constantly, even when the machine is switched off. Fabric softener was not rinsed in, the æ compartment is filled with water. Possible Cause Remedy Close the water tap, remove the mains plug and inform your local Service Force Centre. Clean the detergent dispenser drawer and attach the conditioner insert correctly. Pay attention to the maximum load quantity (see the Programme Tables). In the case of easy-care fabrics, select the EASY IRON programme. The Aqua Control anti-flood system has been activated. The insert in the compartment for conditioners is not correctly attached or is blocked. The washing is heavily creased. Probably too much washing has been put in the drum. The washing has not been spun as dry as usual. The washing was not able to Always load the drum as ful be distributed evenly in the as possible with a combinadrum prior to spinning. The maximum pump height (outlet height 1m from the base surface of the appliance) is exceeded. [. . . ] · Costs incurred for calls to put right an appliance which is improperly installed or calls to appliances outside the United Kingdom. · Appliances found to be in use within a commercial environment, plus those which are subject to rental agreements. · Products of AEG manufacture which are not marketed by AEG. European Guarantee If you should move to another country within Europe then your guarantee moves with you to your new home subject to the following qualifications: · The guarantee starts from the date you first purchased your product. · The guarantee is for the same period and to the same extent for labour and parts as exists in the new country of use for this brand or range of products. [. . . ]