User manual AEG-ELECTROLUX LAV935IW

[. . . ] The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. Tips and information about economical and ecological use of the machine are marked with the clover symbol. Should any problems arise, this booklet provides instructions on how to solve them by yourself; see section "Something not working?". If this information is not sufficient, please contact our nearest Service centre (address and telephone numbers are indicated on the enclosed leaflet). Printed on recycled paper. [. . . ] Pour the main wash detergent into compartment . If you wish to perform a prewash, pour detergent also into compartment . Pour the fabric softener into compartment without exceeding the "MAX" mark. Lavamat 102 Lavamat 61-81 Select the wash programme and temperature Turn the programme selector dial to the right to the required programme. Turn the temperature selector dial to the required setting. 54 CBA 70 60 5 0 QP N 30 40 How to wash Select the required option Press the 600 500 400 button according to the model or the anticrease button KIRIÇIK ÖNLEYICI (SUDA BEKLETME) if required. 1000 800 600 Start the programme Press the ON/OFF (AÇMA KAPAMA) button: the mains-on light comes on and the programme starts. AÇMA KAPAMA End of the programme The machine stops automatically. If the anticrease option has been selected, empty out the water before opening the door: - press the anticrease KIRIÇIK ÖNLEYICI (SUDA BEKLETME) button for a short spin after emptying, or - select the drain programme (BOÇALTMA). Press the ON/OFF (AÇMA KAPAMA) button again to switch the machine off. Release any buttons which have been pressed. Wait two minutes before opening the door to give the safety locking device time to release. Check that the drum is completely empty, by rotating it manually, in order to avoid any garments left in the drum being damaged (for example shrunk) during a subsequent wash, or their colour running into a subsequent load of laundry. · Place the end of the drain hose and that of the inlet hose in a bowl placed on the floor. · Select the draining programme and run it until the machine stops. · Remove the plug from the socket. · Screw the water inlet hose back on and put the drain hose back in its place. By doing this, any water remaining in the machine is removed, avoiding the formation of ice and, consequently, breakage of the affected parts. When you use the machine again, make sure that the ambient temperature is above 0°C. 61 Something not working? If, during the spin cycle, the machine makes an unusual whistling noise, different from the noise made by traditional washing machines, this is due to a new type of motor. If water is not visible in the drum, this is due to the modern technology of new washing machines that use less water than traditional machines. Troubleshooting If a problem arises, you can try to solve it yourself following the instructions below. If you call out an engineer when one of the following problems arises, or to repair a fault due to incorrect use, the callout will be charged even if requested within the guarantee period. Problem Possible cause Solution The plug is not connected. The door is not properly The machine does not work closed. The programme selector dial has not been set correctly. The water inlet hose is squashed or kinked. [. . . ] Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. · The floor surface must be clean and dry, without any wax or polish residue to avoid any possibility of sliding. Do not use viscous substances to move the appliance into place by sliding it across the floor. [. . . ]