User manual AEG-ELECTROLUX LAVALOGIC1620

[. . . ] LAVAMAT LAVALOGIC 1620 Washing Machine User information Dear Customer, Please read this user information carefully and keep it to refer to later. Please pass the user information on to any future owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning!Information that affects your personal safety. Information that prevents damage to the appliance. [. . . ] Press the START key. The transit packaging has not Removing the transit been removed. Adjust the feet as described in the installation and connection instructions. 29 Problem Washing has not been spun. Possible cause Only a few large items of washing in the drum. Remedy Always load the drum as full as possible. Mix large and small items. The screw connection on the Screw the inlet hose in inlet hose is leaking. Water is leaking out from under the washing machine. The drain pump cover is not closed properly. w compartment for conditioners is filled with water. The door cannot be opened when the appliance is switched on. The conditioner insert is not correctly set into the additive compartment or is blocked. There may have been too much washing in the machine. Load washing carefully for the next wash. Close off emergency drain hose properly. Clean the detergent dispenser drawer, insert the conditioner insert firmly. Observe maximum loads. The door is locked for safety reasons. Wait until the O symbol appears. The display goes out while a wash cycle is running. Power cut. For safety reasons, the door will remain locked for approx. 4 minutes. The programme will continue when the power cut is over. To remove washing: If water can be seen in the appliance, before opening the door, first perform an emergency drain. The background illumination of the display has gone out even though the appliance is switched on. The washing machine is in stand-by mode. Press any key. 30 Problem Water is not entering the appliance. ATTENTION ERROR CODE (E11)/PLEASE OPEN THE WATER TAP appears in the display. The washing has not been spun thoroughly and water remains visible in the drum. ATTENTION ERROR CODE (E21)/PLEASE CHECK THE WATER DRAINAGE appears in the display. Possible cause Tap turned off. The filter in the threaded inlet hose fitting is blocked. Remedy Turn on the tap. Unscrew the hose, take out the filter and clean it. Water tap is furred with lime Check the tap and have it scale or is faulty. Remove kink. Maximum pumping height of Please contact your Local 1m exceeded. For sink spigot connections: The sink spigot is blocked. [. . . ] Box 21587 Nicosia 1511 Service Telephones: Nicosia 02 481226 Limassol 05 562182 Larnaca 04 633929 Paphos 06 932 699 Estonia Electrolux Estonia Ltd. Mustamäe tee 24 EE0006 Tallinn Tel. : (372) 6 650 090 Fax: (372) 6 650 092 Kuwait/Arabian Gulf Ali Al-Ghanim Est. Box 21540 - Safat Tel. : 4822190 Fax: 4820116 Lebanon Adib & Assaferi P. O. Box 539 Tripoli Latvia Electrolux Latvija Ltd. [. . . ]