User manual AEG-ELECTROLUX LAVAMAT 50430W

[. . . ] LAVAMAT 50430 Washing Machine User information Dear Customer, Please read this instruction book carefully before using the appliance. Please ensure you fully understand the safety instructions on the first pages of this instruction book. Retain the instruction book for future reference, and pass it on to any future owners. 1 The warning triangle and / or key words (Warning!, Caution!, Important!) give information that is important for your safety or the function of the appliance is highlighted. It is imperative that this information is observed. 0 1. [. . . ] Open the water tap. Close the water tap. Unscrew Filter in screw connection of the hose from the tap, remove the filter and clean it the inlet hose is blocked. under running water. It may be necessary to reduce the amount of deterExcessive foaming dur- Probably too much detergent gent used. was used gent manufacturer's recommendations. 29 Operating Instructions Problem Possible Cause The transport packaging has not been removed. Remedy Remove transport packaging according to the installation and connection instructions. Adjust the feet according to the installation and connection instructions. The machine is not level. The washing machine vibrates during operation or is unstable. There is very little washing in This does not impair the the drum (e. g. The water could not be completely pumped out before spinning because the drain hose is kinked or the drain pump is blocked. Check the drain hose and remove any kink if necessary, or clean the drain pump and, if required, remove foreign bodies from the pump housing. The screw connection on the Tighten the inlet hose screw inlet hose is leaking. connection The drainage hose is leaking. The drain pump cover is not correctly closed. Water runs out from under the washing machine. Check the drainage hose and replace it if necessary. Stop the program and remove the washing caught in the door. Seal the emergency emptying hose correctly (see section "Carrying Out an Emergency Emptying"). Call your local AEG Service Force Centre if the emergency emptying hose leaks. Release SOAKING button (main wash program will follow). The emergency emptying hose is not correctly sealed or is leaking. The washing machine does not spin; there is water in the drum. RINSE HOLD has been selected. Soaking program has finished. 30 Operating Instructions Problem Fabric softener was not washed into machine; drawer æ for conditioner is filled with water. Possible Cause Remedy The conditioner insert has Clean the detergent disnot been correctly positioned penser drawer and attach the inside the conditioner comconditioner insert securely. Pay attention to the maximum load quantity (see Program tables). In the case of easy-care fabrics, select the EASY IRON program. Remove the kink. Washing is heavily creased Probably too much washing was put into the drum. Drain hose is kinked. Contact your local Service Force Centre. [. . . ] Box 1 15 29 Jeddah Tel. : 6606852 Latavia Electrolux Latavia Ltd. Terlaton Street 42/44 1011 Riga Tel. : 371 2 297821 Fax: 371 2 821286 Lthuania Electrolux Lthuania Verkui 29 2600 Vilnus Tel. : 372 272 3326 Fax: 372 272 3366 Malaysia Arzbergh Engineering No. 49A/B, Jalan Petaling Utama 7 4600 Petaling Jaya Tel. : 3 795 1084 Fax: 3 795 1082 49 Warranty conditions Singapore Japan Arzbergh Engineering Electrolux Japan Ltd. Yasuda Warehouse 4F 3-3-12 19 Tanglin Road 06-07 Singapore 247909 Heiwajima Ota-Ku Tel. : 65 7356572 Tokyo Fax: 7351124 Tel. : 81 3 3544 3363 Fax: 81 3 3763 6143 Thailand OLYMPIA Thai Ltd. [. . . ]